I'm finally getting around to working on my L275DT, and one of the major issues is the poor condition of the wiring harness. Below is a connector that is below the fuel tank and has been soaked in diesel, has burned wires and has many years on it. I see a number of options for generic connectors (Amazon, Ebay, etc) that I could combine to equal this one. One issue is that the wire gauges are not all the same, so that will be a problem with generics. I'm assuming that these will have been obsoleted or are no longer available. I have seen one site that does have custom made replacement harnesses for this tractor, and I wouldn't mind spending the money, but they only offer 2 of the 5 total harnesses, so would be of limited use to me.
Looking at similar forum posts here I see a number of people are making their own harnesses, which I'm open to. Where would be a good place to get the parts & wiring for that?
My 3-wire connector on the alternator is still working but pretty broken up. I saw posts where others had replaced their alternator with presumably a more modern one that had different wiring requirements. Can anyone tell me more about this? I do not think that my alternator is charging now, based on multimeter readings at the battery when running.
Looking at similar forum posts here I see a number of people are making their own harnesses, which I'm open to. Where would be a good place to get the parts & wiring for that?
My 3-wire connector on the alternator is still working but pretty broken up. I saw posts where others had replaced their alternator with presumably a more modern one that had different wiring requirements. Can anyone tell me more about this? I do not think that my alternator is charging now, based on multimeter readings at the battery when running.