i remember when.....

wgator

Active member

Equipment
L4701HST, FEL and other stuff.
Jul 28, 2018
482
147
43
NC
I remember when a gas engine car tune up only required a;
9/16 dist wrench.
Feeler gauge for the points and plugs.
A tach and dwell meter to adjust the idle rpm setting and points operation.
A timing light to set the timing.

Feel free to add anything I forgot
I still have these in my "tool box of meters"
 

Magicman

Well-known member
Lifetime Member

Equipment
M4900 Utility Special 4WD e/w FEL & 1530 John Deere "Traveling Man"
Oct 8, 2019
5,505
7,567
113
81
Brookhaven, MS
knotholesawmill.com
I bought a "new to me" tractor last September and backtracked to a 2005 M4900, to avoid getting a common rail engine. I bought a new MS362 Stihl chainsaw last year and did not get the CM.

I am trying to keep my life simple and avoid being dependent upon a dealer's computer when I need service.
 

Bountyhunter

Member
Oct 13, 2019
32
7
8
Alberta
Don't
I remember when a gas engine car tune up only required a;
9/16 dist wrench.
Feeler gauge for the points and plugs.
A tach and dwell meter to adjust the idle rpm setting and points operation.
A timing light to set the timing.

Feel free to add anything I forgot
I still have these in my "tool box of meters"
Don't forget that it had to be done every spring and fall, and maybe a points adjustment in between just for good measure.
 

skeets

Well-known member

Equipment
BX 2360 /B2601
Oct 2, 2009
14,553
3,303
113
SW Pa
And if you were going out on Friday or Saturday nights when you changed plugs you made sure you indexed them, and flipped the lid over on the air cleaner and yep some place there is a light and a dwell meter, and parts to a Malory rev pull distributor,, just more junk for the kids to toss one day :)
 
  • Like
Reactions: 1 user

Nicfin36

Well-known member

Equipment
L2501 HST, BH77 Backhoe, SSQA Loader ZD1011 Mower
Jun 19, 2019
1,016
466
83
Decatur, AL
My first car (77 Corolla) had points which literally broke in two one time, stranding me on the highway, and I was out of town. Of course, no cell phones then. I had to cut some speaker wire and wired the points back together. It got me home.

I also remember giving the carburetor a good squirt of carb cleaner from time to time.
 

Bmyers

Well-known member
Lifetime Member

Equipment
Grand L3560 with LA805 loader, EA 55" Wicked Grapple, SBX72 BB, LP 1272 mower
May 27, 2019
3,293
3,849
113
Southern Illinois
I remember when phones had dials on them and the handle was connected by a cord.
I remember when you had to listen to the rings to make sure the call was for your house (party line at my grandparents).
I remember when there was enough room that I could stand inside the engine compartment of the F150 to work on it (before they added all the pollution control).
I remember when you had a choice between regular and unleaded gas.
I remember when the car came with a full size spare and a bumper jack.
 

SidecarFlip

Banned

Equipment
M9000HDCC3, M9000HD, Kubota GS850 Sidekick
Oct 28, 2018
7,197
555
83
USA
And if you were going out on Friday or Saturday nights when you changed plugs you made sure you indexed them, and flipped the lid over on the air cleaner and yep some place there is a light and a dwell meter, and parts to a Malory rev pull distributor,, just more junk for the kids to toss one day :)
Gotta make that motor sound like a vacuum cleaner when you mash the loud pedal to impress your girlfriend.....

Today, you need to be a computer programmer to 'tune' a motor.

I am so, so glad all my diesels are conventional injection. Even my unit injected pickup truck is better than the common rail crap and all the hardware associated with it.
 

nbking

Active member

Equipment
L2501HST 4X4, Rtv-x900
Jul 8, 2018
221
72
28
Sonora, CA
I remember having to get up and go to the TV to change the channel,
I remember when you had to reheat leftovers on the stove,
I remember reading the Sunday paper, comics, and going through the ads,
 

SidecarFlip

Banned

Equipment
M9000HDCC3, M9000HD, Kubota GS850 Sidekick
Oct 28, 2018
7,197
555
83
USA
I remember when phones had dials on them and the handle was connected by a cord.
I remember when you had to listen to the rings to make sure the call was for your house (party line at my grandparents).
I remember when there was enough room that I could stand inside the engine compartment of the F150 to work on it (before they added all the pollution control).
I remember when you had a choice between regular and unleaded gas.
I remember when the car came with a full size spare and a bumper jack.
My wife's Suburban does (full size spare and jack. Problem is, GM, in their wise ass attitude make the spare tire hoist cable about 3" too short so the only way to get the full size spare (heavy as hell) tire off the hoist cable is get underneath the vehicle and angle the tire and rim up on your shoulder so you can remove the hoist retainer.

Nice design. Just the ticket for some gal on the side of the road with a flat. Everything is there but not useable.

GM should have went tits up instead of getting bailed out by Obozo.

I will say, far as my vehicles (gas engined ones) are concerned, a good quality OBD scan tool is quicker and easier than timing lights, dwell meters and all that stuff. Plug into the OBD port and get all the data instantly and a good (expensive) scan tool will also tell you what needs to be replaced. You really don't need to be a computer whiz either. Someone else did the 'dirty work' for you. You 'pays the price' and 'gets the knowledge in the tool'.
 

Ping

Active member

Equipment
BX2370-1
Dec 25, 2018
311
226
43
Troy, Ohio
I remember when people wouldn't bat an eye if you were riding in the bed of a pickup going down the highway.
And, when you didn't need a drivers license to haul a load of grain to the elevator.
 
  • Like
Reactions: 1 user

SidecarFlip

Banned

Equipment
M9000HDCC3, M9000HD, Kubota GS850 Sidekick
Oct 28, 2018
7,197
555
83
USA
I remember when people wouldn't bat an eye if you were riding in the bed of a pickup going down the highway.
And, when you didn't need a drivers license to haul a load of grain to the elevator.

All that still applies around here. If you are big enough to see over the steering wheel and reach the pedals you are big enough to deliver grain to the co-op. Far as riding in the back of a pickup, they do that too but it is illegal,
 

Russell King

Well-known member
Lifetime Member

Equipment
L185F, Modern Ag Competitor 4’ shredder, Rhino tiller, rear dirt scoop
Jun 17, 2012
5,358
1,413
113
Austin, Texas
I remember riding on the tailgate of our pickup for miles and miles. Had to hold your feet up if going through a sharp dip.

And riding in the rear facing seat of the station wagon with legs and feet right in front of the bumper.

We never considered how dangerous either of those were.
 

skeets

Well-known member

Equipment
BX 2360 /B2601
Oct 2, 2009
14,553
3,303
113
SW Pa
Yes I remember a pick up truck with a ton of kids headed to the drive in,, some times they has a special one price a car load,, I dont think we ever lost anybody on those trips
 
  • Like
Reactions: 1 user

BigG

Well-known member

Equipment
l2501, FEL, BB, Rotary cutter, rake,spreader, roller, etc. New Holland TL80 A
Sep 14, 2018
1,951
770
113
West Central,FL
Yes I remember a pick up truck with a ton of kids headed to the drive in,, some times they has a special one price a car load,, I dont think we ever lost anybody on those trips
$5 per load for all 8. One of the damn fools found a piece of rope and was flying a folded up lawn chair out the back like a kite on the way home. I could have killed him.
 

RCW

Well-known member
Lifetime Member

Equipment
BX2360, FEL, MMM, BX2750D snowblower. 1953 Minneapolis Moline ZAU
Apr 28, 2013
9,134
5,194
113
Chenango County, NY
Drive-in’s and pick up trucks.....

Young gals and drive-in’s.....God, was it great to grow up in the era of Drive-In’s......:cool::cool::cool:


I would load my truck with a bunch of buddies, lawn chairs and beer for the XXX double-feature. No truck load special, so my buds would jump out outside, then sneak in. I would drive in alone with a whole bunch of beer and chairs.....Person at the ticket booth would just smile.....:)
 

armylifer

Well-known member
Lifetime Member

Equipment
BX1860, FEL, RCK54P MMM, BB1548 Box Scraper, Quick Hitch, Piranha Bar, BX6315
Mar 26, 2013
2,045
782
113
Thurston County, WA
I remember spending Saturday nights racing from stop light to stop light on "the Ave". After the cops showed up and dispersed or ticketed the racers, we would spend the remainder of the night "cruising for chicks" and buying beer from taverns that would sell it to anyone that "forgot their ID" for $2.00 per 6 pack. The 6 pack would cost only $1.25 if you had ID that said you were 21.