B2650cab with Landpride RGR1258

[Duke]

I have 3" spacers on my B2650 with turf tires which should put it at 60" wide. With the 58" wide tiller I will be 2" wider than the tiller's cutting path.
My question is will being 1" wider on each side really make a difference?
My thought is if it is than I could offset the 3 point to one side a couple inches if I have to but I would rather not.

 

[beckmurph]

You can loosen the u-bolts, that hold the lower link mounts, on your tiller. Then slide the mounts left or right to offset your tiller.


Sent from my iPhone using Tapatalk

 

[Freeheeler]

As far as I know mine is stock, so I don't know if there are any spacers or not. When I measured, I went from the outermost sidewall point and it was just a fraction under 60". The actual footprint width of the tread (contact with the ground) is more like just under 56". I don't think you'll be leaving tread marks with the 58" tiller, certainly not enough to make offsetting to one side a benefit. I'll actually measure the tread width tonight for curiosity.

 

[Duke]

Well I measured across the outside edges of the tread and not the sidewalls and came up with 58” right on the money. So if I can drive really really straight and NO BEER then the RGR1258 should be fine.