I will provide as much of information as possible to insure a prompt response. I have a 2006 B21 TLB with approximately 620 hours. The backhoe has been removed for the third winter to allow the use of my 42 inch snow blower. The hydraulic/transmission fluid and filters were changed within the last 20 hours. The pick up screen was also cleaned. The fluid is Super UDT. The front end loaded works without problem. The tractor moves well and the hydraulic chute control operates properly. After approxiamtely 5 hours of use, over three uses to clear snow with the snowblower the 3 point point hitch will not lift the snowblower. The lift arms will operate upward without any load. There is no binding in lifting the snowblower as I have actually lifted it up with a floor jack. I have checked the hose connections and they appear to be good. I have moved the hitch lowering knob to full open, half open and closed without any change in my problem.The selector valve lever is in a full up position and I have turned it on and off multiple times. I have also varied the position control lever many times. The 3 point hitch was working properly and stopped suddenly approximately 45 minutes in a session removing snow. The temperature has been between -10 and -20 C for the last two weeks and the tractor is stored in an unheated closed garage.
I will answer any questions that I have not already addressed in the information.
The snow blower does work on the PTO but the 3 point hitch will not lift the snowblower.
Please provide a list of recommended items to check in your suggested order.
Looking forward to your suggestions.
I will answer any questions that I have not already addressed in the information.
The snow blower does work on the PTO but the 3 point hitch will not lift the snowblower.
Please provide a list of recommended items to check in your suggested order.
Looking forward to your suggestions.