Search results

A Kubota BX 2200 series have overheat problems I have both a BX 2200 and a BX-22 problems are the same on both done many changes but really haven't got where I want to be the changes have been new thermostat new fan belt new radiator coolant replacement new fan from a bx2680 was my best...

I finally got back to my mid PTO shaft spline problem I purchased a adapter that goes from a 31 /32 -10 spline inside and a 1 3/8-6 spline on the outside the part was $26.99 problem solved thanks for the input from all of you

I'm working on the same problem myself for a Kubota BX 2200 will crawl under and measure tonight would have found online comments of three sizes two of what you listed 31/32 10 25 mm 10 and 1 in 10 just wondering if you found out which one it actually is thank you

I have had overheating problems with both a bx22 and a bx2200 tried a lot of things and still not really satisfied with the results but my best change in the system was to take a fan from a BX 2680 which is a five blade fan turn it down slightly and put that in air flow has increased and a...

I set up the fan from the bx26 seriines on a Milling table and rotated it through a half inch End Mill taking off.100 inches at a time doesn't take very to reduce the diameter of the fan from 11 and 3/4 to to 10 and a quarter inches project took about 3 and 1/2 hours

TThere have been a lot post BX series running hot with many suggestions these tractors are very sensitive to air flow through the radiator so what I did was I got a fan from a BX 2680 which has five blades trimmed it down and put it on the BX series 2200 seems eliminated the

The BX 2200 tend to be sensitive to air flow when it comes to Cooling there have been many suggestions I've seen online about improving a situation such as new radiator belt blow out the breed it has collected on the outside of the radiator clean it flush the radiator change the ratio of water...

L 4310 with hydrostatic transmission and cab

As for the loader bucket I purchased an old unit off of 3020 John Deere cut up the arms and the cylinders 2 match a la 681 in approximate size but have not done anything with the valves of the connections yet and it's sitting in the shop

Currently the tractor has no hydraulic connections would like to install at least two and may occasionally use on a loader bucket

Yes Kubota runs about $1700 or so for the TA040-96102 valve

There is a valve assembly used for the rear remotes the assemble number is TA040-96100 or Ta040=96102 Does any one know what valves are used of this option on a L4310 tractor

These tractors tend to have the boots missing on the drive shaft from the motor to the hydrostatic transmission which is also the same shaft with the fan for cooling the hydrostatic system when the boots are missing often the joint on both ends where the what time is it in are worn out as well I...

I have two Kubota BX2200 and both tend to run hot the radiator and all screens must be spotless. On one of the tractors I installed a after mart radiator from a Honda auto this one has three rows of tubes and aluminum top and bottom tanks. Re bending of the shroud was required. Plan on a...

The bx 2200 and bx series tractors tend to run hot and are very sensitive to lack of air flow through the radiator. i have made one major change on my Kubota bx 2200 a after mart radiator for a Honda auto it has three rows of tubes and aluminum tanks top and bottom of the radiator. Rework of...