Search results

Thanks ... Mine is about the same now after the adjustment.

Hello All ... Closing the loop on this thread. Spoke with my dealer and there is an adjustment (see pic below) that sets the upper limit. You can go as high as where The lift arm would hit the bottom of the hydraulic cylinder - you want 3/4 of an inch for play. By shortening the linkage it...

Retried it all and the middle hole actually has it the highest point as past vertical support angle change causes it to lower ... Gained a bit but still way off. that said I noticed that from the lowest level I have to raise the control lever past about 1/3 to get the arms to move at all ... I...

No specs that I can find ...

it's and has been in the furtherest out hole and the extension to aid hooking up only has one "locked" position at it's shortest configuration

EA 6900 HD

I would be curious if your max/min height is same as mine as shown below with no attachment 26 max - 8 min

So at its highest ... How much clearance do you have at the front of the cutter? I get about 5 inches at max ... When trying to connect my auger this as high as it goes ... Cannot even get the auger under the gear box

Lift arms are in the longest configuration, the side links are as short as possible now which helped over how it was delivered by about an inch as it was already very short ...

Yes I went to look again, and see what you m Ah yes, thanks I was interpreting what I was seeing incorrectly ... The link to the parts schematic is very helpful. Have you ever adjusted the feedback linkage to change the lift characteristics?

Interesting perspective - however I find it odd that the 5 tractors that I have used in my life before all could lift an auger above the ground so that it could be attached and actually used as an auger. Never had problems with down force, clearance or geometry - I guess we knew how to use an...

Travel lock is not an issue, side linkages are as short as possible ... Not sure about the hydraulic cylinders, I thought those were part of the draft control??

Forgive my ignorance - but by Feedback linkage, is that the adjustable side links or something else? I have shortened the adjustable side links to their shortest settings With nothing attached, the movement is only about 17 inches measured at the ball connector on the lift arm Thanks for...

Yes tried all 3 holes for both the bush hog and post hole auger ... Didn't make a significant difference. Thanks for the idea...

Have you contacted your dealer or found out anything?? It is unusable as it stands now

New to the forum and to Kubota I just took delivery of a new M6060 and the 3 point will not raise high enough to mount the auger on my post hole digger. I also noticed it only lifts my BushHog about 5 inches off the ground. I checked both side linkages to make sure they are as short as...