Search results

Thank you all yes I believe it was the right direction. But I will double check this weekend. Yeah I was afraid it was the gauge cluster.

Sorry all, anyone have any insight on this?

So with the drill attached to the cable I get nothing at the dash. I pulled the dash and it looks like the speedos square ed that fits into the gauge behind the panel is a sloppy fit. Everything spins but when I attach it and make sure the cables fully inserted into the sheath and into the gauge...

I'm having an issue where my b2410 will not register above about 1500 RPM. Audibly the RPMs are increasing. I can see the throttle linkage moving its full range of motion at the injector pump. I assumed it was my Speedo cable so I replaced that with a factory OEM cable. No change. Any thoughts?

Okay. The second I tried move out to the third hole it just looked horribly off obviously. But thank you for the confirmation.

That's actually what got me thinking. With nothing on it it does not move till number 5? It will drop all the way to the floor below number 5 with no implement

So that be normal, what is the value of 0-6 on the position control? Does it work with other implements? I've been using it with a box blade.

I was going to widen my stance a little. I am currently on the middle hole on my axle. Question is when I position tires on the 3rd hole the axle is barely in the hub. I attached pictures. Including from the service manual. My tire size is not listed. And I'm confused about the comment in...

Is it normal for position control to do nothing until the 3pt lever is in the number 6 range? From there it seems to work appropriatly. But any number below that drops the 3pt all the way down....

Thanks for the info. Got a quote in with the woods dealer now. Still little concerned about the potential digging power. Might just have to pick the right time of year to do bigger jobs

I have a b2410 with front loader, currently my local Woods dealer is getting me a quote on a Woods 65 with subframe. What kind of digging power can I expect with this set-up? Main use would be for digging a few trenches for water lines, have multiple retaining walls to build that need footings...

Is there anything between going full hydraulic tip and tilt which will cost me like $3,000 and just replacing my top and side length with the old standbys. They're both stiff and bound up and with tendonitis in my elbows im having a hard time adjusting my box blade. Is there something that's...

Is it possible to add a Top and Tilt setup on a B2410 without having to install a rear remote kit? Meaning with the right valve can a TNT kit be plumbed in to the valve? Trying to keep cost down. So just a top link, side cylinder, valve, tubing and fittings and a way to mount it? Or do I...