Search results

We have a newer m6060 that has the hydraulic block on rear for implement connection. We also have a m9000 with 2 of these blocks stacked on top of each other. The units look the same have same dimensions. Is there any reason why we can't take one of the blocks from the 9000 and stack it on...

M9540 has hydraulic leak from the output shaft at rear of tractor. I'm working on obtaining WSM but wanted to ask if that seal is serviceable without disassembling the entire tractor.

M 9000 rebuilt the forward reverse shifter and replace the ball shaped bearing on shifter shaft. Tilt steering column. The shift linkages are not properly adjusted. Can someone direct me to the procedure for adjusting? The adjusters are under floor plate.

My tractor and I, m9540, are out in a field with cube cart. The situation: start move forward and after say 30 seconds loses power. Stop and idles okay. Very little fuel in inline fuel filter. Shut off tractor fills up with fuel. Took off separator housing removed some trash at inlet elbow...

I'm new here but it's getting cold and the 2000 m9000 has no heat from vents. Where is the heater core located? Is there a inline shut off valve in these tractors as I have read about? Lastly, any special cooant refill procedure? Thank you in advance

my second attempt to post for help, first one disappeared..My m 9000 when put into forward pops out of gear when clutch is let out. If I hold the lever up it stays in gear and after clutch is released i can let go and it stays in gear. Stop and put into reverse with no issues. The lever has...