Search results

New to me International Harvester Cub 154 Lo-Boy. Clutch died but it came with a new one in a box. Hadn't started it yet because to PO took some of it apart. Running wise it looks like a complete tractor minus the deck. It's a 3 speed 4 cylinder gas with I think a whopping 17 horse power. Rear...

Permatex 20539 Indian Head Gasket Shellac for me.

That sounds bad. Busted rings?

I'm surrounded by pine trees and the needles and pine cones usually keep the bottom of my decks clean. Like the previous answer of letting them chew some sticks to keep clean. I do have a sweeper but it doesn't get all of them. The ones left over clean the deck.

I gave a copy of the workshop manual that explains the function and overhaul in detail but I don't think I can post a PDF file that large here.

I have a axle leak on mine and forward gets sluggish before reverse when the fluid gets low. A little air in the system and it starts acting up. Will the wheels roll forward with the rear end off the ground? Fluid level good?

Was this problem following a fluid and filter change?

That's every 5 minutes for me. What were we talking about again?

My XM antenna leaked on mine (2015) and was causing problems in my steering wheel controls. Dealer fixed the seal, still have some ghost issues from time to time. I had water leaking on my lap during rain and car washes.

Did you ever find the draw bar?

Unless I bust a spendle I'll always just replace bearings without removing them from the deck. Cheap or expensive you can't really grease them unless you remove the inboard dust seals on the top and bottom bearings. The cheap bearings all have life time grease cause the bearing will fail first...

Don't know if the T1760 has the same combination box that the T1600 does. They can go bad as well as the corroded cables and other bad connections/switches. Mine finally died and it would click over the relays that were inside the combo box but the starter wouldn't spin. I installed a helper...

Thanks! I got the fuel pump leak fixed today or at very best extremely slow now. I also picked up a PTO log splitter! It's old and still works but going to see very little use with the rear exhaust this tractor has. It is a Unicorn splitter. And I've only seen these in pictures and videos.

Looking for one 13.6-28 R1 tire in GA or a link to the thread where everyone was talking about recommendations for new ones. Thanks

Also Bush hog, planter, and Ford bottom plow.

New radiator cap and new ignition switch. The one that was in it was generic and not working correctly. Yes, the new switch is a Kubota switch. I didn't like the replacement Ford switch keys. Also is the Rhino FM72 finish mower I got with this tractor. The blades were upside down, fixed that and...

Thanks

Draw bar I found in the woods behind my house and seat adjustment knob I don't know how to operate or it's frozen.

This has the suspension seat on it and appears to be stuck or I don't know how to work it. Looks like the knob is rusted solid not allowing for adjustments. Is it supposed to turn or be pulled up or pushed down to make it work? Thanks I'll get a picture when I get home today.

I have one I found in the woods behind my house. Your very generous though and the offer is much appreciated!