Search results

Have you thought about calling Kubota credit and asking them?:D

CJN8 You are correct. 850 lbs per Kubota.Ca:D

You state that your dealer is the only one that has hauled your L39. I believe your tlb was shipped from the factory by truck in 1 piece, assembled. Dealers driver would not have used those links to strap the tractor down. You might think about replacing both of those links. Because, just...

You mentioned mowing a ditch, this might work: http://www.drpower.com/power-equipment/trimmer-mowers/tow-behind/ :D:cool:

could you give some details on bachoe?

No smoke and no fire, sounds like an electrical problem. I would look for a loose wire, or faulty safety switch. Look at the wiring going to your fuel pump. A loose wire to your fuel pump would act like this. Good luck.

Bx25 and the bh65 do the same thing. I expected that on the BX25, but not on the bh65. 1 function will take precedent over the other. When I bought the B3200 with the bh77, I found that I could use 2 functions at the same time. Your bh65 is a strong backhoe. I did a lot of work with my b2620...

Is there a slip clutch on your mower? What brand and model of mower do you have?

By using a harder bolt (gr5 instead of gr2), you are taking a chance on breaking something other than a shear pin. If you were only cutting grass or weeds, what broke the shear pin? Is this a new brush cutter, or one you have had for a while?

:eek: There are several things on Kubota's, on your side of the pond , that are not available in the US. One of them is a mulching kit for B series tractors.

High gear is for transport, or cutting grass on fairly flat ground. You need to be in low range to climb just a moderate hill. The HST peddle is not an accelerator like in your auto. It is your gear shift. The less peddle applied, the more power/torque to move things. (LOW GEAR) The more...

You can offset the RFM to one side and get Fairly close. I use a push mower to Trim around house and trees. The MMM is better for close trimming

The mowers on the B series cut well. But there are no mulching blades available from Kubota for these decks. And you will get a lot of clippings from the mower. I have owned both a b2620 and B3200 with mmm's. They cut well, and my "yard" looks good after mowing with these mowers. But if you let...

According to Kubota's web site, overall height is 84.6". :eek:

It is specific to the BH77. I guessed that since he had a B3200, that it was a BH77 on his tractor. :D

Check your 3ph lift control on the right side. Make sure it is in the full open position. All the way forward. With your backhoe installed, that affects the way your hydraulics operate if the lift control is not all the way open.:)

:mad: Well, that link didn't work. It looks like that spring should be, about, under your right foot.:)

http://kpadweb.kubota.co.jp/kpad2/PartsInfo.do?bookCd=100K5120&funcCd=&figNo=D00100&dispType=2 If this works: It is a return spring on your HST. It is the 110 part in this link. If this link does not work, go to Kubota.com. Go to the parts section. look your B3300 and look under the Hst section...

ORANGEMADMAX If you go to Kubota.com and build your B2650, there are 2 blowers listed. There are 51" and 63" front mounted snow blowers . On Kubota.ca (Canada), there are also 2 rear mounted snow blowers. :cool:

There is pressure in the system. Either the hydraulic oil has warmed up or you didn't relieve all the pressure when you disconnected the hoses. Take the female end of the QC. Using a wood dowel or small drill bit. Put the dowel/drill bit on the dimple in the female QC. Place a rag around the...