Search results

Take your time and see what others in your area chose for their building type. If you can afford to get the shop of dreams in one shot great, if not consider expandable end walls, height for future lean to, etc. Here's a question can a shop every be too big?

Consider a top and tilt conversion.

I wouldn't think how they connect to the tractor matters, as long as the coupling side (male/female) is compatible with your equipment. and polarized correctly.

Use a screened funnel when filling your equipment. Behrens Galv Tractor Funnel 8Qt GTF123 | Zoro Giant Plastic Funnel 6qt Red | Agri Supply

I do as DustyRusty does, but I also drop the three-point linkage and use a spring clamp to keep the third function buttons on.

Pending the battery's age/condition confirm that the posts, terminals and connection points (positive/negative) are clean (not just tight!), if a replacement is deemed necessary, take the three measurements and get one with the highest cold cranking amps that fits.

My front tires are 12-16.5 R4's, around the tire close to the bead on both sides, in 4 places are the words "RIM GUARD" with an arrow on both sides of the words pointing to the rim, what's the story on this? Thanks

This is what I fabricated up 586#'s, the pipe is great at filling and smoothing ruts, pulling trailers/ goose neck and carries 40' (2-20's) of chain.

I use smudge pots to get rid of my waste oil. I find it's easier than starting campfires and when I go in for the night, just close the shutter and lid, next morning just fire it up.

I assume both battery posts/terminals are clean. Sounds like a bad battery ground cable (is it the woven type) or where the ground connects to the engine needs cleaning. To prove, take one jumper cable and go from the negative on the battery and connect the other end to the starter mounting bolt.

The painter has a lot of faith in the operator, if he swings the bucket and gets tangled in those power lines, yikes!

Interesting read on this subject. How Mohawk ‘Skywalkers’ Helped Build New York City's Tallest Skyscrapers | HISTORY

Tongs have their use, haven't used mine in 15 years. These are the best (4 Pack) Logging Chain Choker Hook - 5/16" 2 Tons 4500 Lbs WLL (myteeproducts.com)

We all get spoiled, with just a few mouse clicks and stuff comes to us. I to have had poor delivery and wrong items show up. But all in all, it's amazing for the amount of product that moves from the supplier and vendors to UPS, FedEx, USPS. Be glad I not the person putting stuff in boxes for...

I'd have someone come in with a large excavator with a thumb, dig around and push it over stump and all. While you cut up the tree, let him take down the chicken house and dig you a pit, shove everything in the hole and burn it all. When you bring a dozer to remove the topsoil (save for later)...

I hope you did a Phase I environmental site assessment prior to purchase. Will you be on community water or private well?

You're on the right track remove the bungs and inspect, if it looks acceptable, then hydro the tank to 1.5 to 2 times the rated pressure. It's better to find out now if the tank is up to suff.

If the rod is the only thing broken and the other parts are still attached, just purchase the rod. I'd suggest changing it yourself. Purchase a WSM which will show how to properly adjust it.

Check the parts diagram, if the flywheel has damage you may need to have it resurfaced and it would be the time to change the rear seal. Front transmission seal? Make up some pilot pins and have a disk aliment shaft, to make reassembly easier.

In your first post you indicated that you shouldn't worry about it, but it worried you enough to ask. Not sure about you, but when I was growing up, I watched my than my fair share of Westerns and still do, I'd bet that over 80% were based on land grabs and disputes. The Indians didn't worry...