Search results

That's what I thought they're hard on a tractor, and I wanted to dig stumps out?

I have a chance to buy a Woods 3-point backhoe model 750 from 1987 that is in excellent condition for $3,500 I'm going to put it on a L3010, would this be a good combination?

SOLD

I have 2 Kubota RC60-71B mower decks for sale one is a parts deck with damage to the center spindle deck housing, it has a crack in this area the other is a complete deck with all necessary hardware to attach Kubota B7100HST 2nd generation tractors, early 1990's models . 

UPDATE: problem found and solved. it is the fuse holder block, bottom fuse does not make contact with terminal, bend fuse up a bit on left side and tractor shuts off with key!

Went to the trash, nobody wanted them.

F's interchange. can't answer the pto, usually you need the right one.

You don't need to split the case. Dig the oil seal out, you will see a circlip holding the bearing in, pull shaft out and remove small circlip on end, remove all from this end, then reinstall with oil seal going on first. 1/2 hour job per side.

34159-11840 I would try Messick's, they can find obsolete parts.

Your tines look like mine and it tills great. Glad to help you, it's nice to see the old stuff still working.(y)

70030-00322 Right 70030-00321 Left These numbers are for a K-422 I have a K-420, no listing for it anymore. It was made by Woods Brothers, your tines are very close to mine. If want to pursue it but at $40 a tine it adds up. I would use what you have, they will till.

They really don't look bad.

You're not going to find information on the Kubota site. I'll try and remember who made it for Kubota. Send me a picture of the tine.

I can, a K-320. vintage 1977

It was a correction of there problem, you should be good to go once you get the right parts. It was put back together without repairing I would say no one knew what was going on at the time. Dealers 40 years is what made Kubota. They could turn around, pick a part off the shelf and you were good...

I believe you need 66706-14380 also 66611-14370 Boss spline. Kubota was having failures with their splines and started making adapters for the earlier models, I think pre 1980, don't hold me to it. I have a b6100 with a crank adapter to run the new style front pto clutch, the finer splines of...

I found that the fuse holder block has issues, wiggle the fuses loose power, cleaned still acting up, I have it working I think I will leave it alone, tractor runs and works, so I pull the knob to shut down, I guess that's why it's there. Electrical is not my favorite trouble shooting. Thanks BK

Yep, project for tomorrow. Time to find out what's going on.

Well thank you, this clarifies my question, time to check the lines and see what's going on, maybe I have a bad new solenoid ? first on my list Saturday morning, I'll let you know what I find.

Thank You.