Search results

I guess I should have put with the tractor not running

Hey how do you disengage the hydro on a b2400 either to tow or to spin rear wheels when on a jack? Or can you and no just in neutral doesn't work

Could be front seal on the engine

Ya my stupid ass when I put it back together I figured I had the yoke for the front drive shaft on all. The way the hole for the roll.pin was good roll pin went in and was working but had a noise n vibration right from the start so needless to say I'm a dummy and now we need a new yoke....

Just seems weird that it didn't do it before we split tractor to change a seal like it will barely engage in 4x4 u have to hold the lever and will shake the shit out of ur arm

B2400 popping out of and will not stay engaged in 4x4 also still grinding noise in high range Any ideas????? Losing my mind

Replaced seal on back of tranny cover the one that goes back to hydro unit and wasn't making noise or vibration before all we did was split tractor and remove cover on back of bell housing area replaced the bearings inside on the shafts and the seal on the output shaft now when driving in...

Hey all just wondering if anyone has had any issues with a vibration and a gross kinda grinding noise when driving in high range. Kinda sounds like low oil issue.. recently had to replace a seal and some bearings behind bell housing area oil level on dipstick is right where it needs to be it...

Hey all recently had to split a b2400 hsd to replace a leaking tranny seal got it back together owner stated no fluid in it I checked before filling and lipstick completely dry. Book says 12 liters got to 8.5L and was over flowing including dipstick tube. Got it running oil went down in...

That's it thank u so much dude

Ha need it to push snow

Hey putting a b2400 hst back together after almost a year apart..... anybody know what this bracket is for??? I can't remember where it goes