Search results

Sorry but I posted the wrong info on my original post. The loader is a LA302-1 not a 272. (even tho the papers where I bought it says 272). The serial number on the loader is 58565. The cylinder shows 75536-03111. Thanks for all your help.

Is there a different serial number for the loader or are you referring to the number on the cylinder itself? I took a picture of the numbers on the cylinder but need to get a better one some letters are not clear enough to be sure what they are.

Can anyone give me the part number of a repair kit for the boom hydraulic cylinder of a LA272 loader

Thanks again for the reply. Only thing on the rear is the box blade sitting on the ground. I have some experience with a JD 4100 for a couple months and years with larger tractors but not much with these small tractors. I just got this one to use around the place. Finding out at my age I can't...

Thanks for your reply. Sorry if I was not clear but yes the float/stick is still there. It seems the last 4 inches travel of the cylinders does not have enough pressure to raise the front of the tractor. Laying 4 x 4 blocks under the bucket it will not lift the tires, however lowering the...

Yes it is new to me and I have used loaders with this feature however I was not aware this loader had that feature. This is on a B7510 and it has 319 hr. on the tractor the valve is a B01303 if that helps. Also I have been playing around with it this morning and noticed it does not have the...

Having trouble with LA302 loader joystick sticking when lowering, any help?

Thanks for the reply. This morning I tried to crank the tractor with no luck so decided to check the battery again. It showed a good 12.5 volts but I decided to put a charger on it anyway and noticed it started charging at 10 amps and did not improve any over 30 minutes. At this point I...

It started the day before but was slow catching up no black smoke or anything and I could not get the glow plugs figured out. Now that is corrected it spins over but just doesn't start. Dad was a old gasoline everything for years so his old saying was correct back then but diesels are a...

Thanks to you fellows I got the dip stick out. Seems there are two O rings around it and either they had been replaced with two that were a tad larger than what should be which made it very difficult to get out. I also found the heat plug indicator had a burnt fuse which I replaced but after...

Thanks. I will check and see if I am doing it right. Maybe I am not waiting long enough for the light to come on. It just does not seem to work like any of the other tractors I have.

Thanks for the reply. I have about decided that is the only way I can get it out. I took the fill cap off and used a clean screwdriver down the fill hole and the fluid level was about 10 inches down. My son works for a company with a lot of Ford trucks and says a lot of them are like my tractor...

I am sure it is but how can I tell if the stick won't come out? How can I put oil or anything on it with it still in the tube? I would think a little grease would help it from sticking if I could just get it out of the tube. I tried removing the fill plug in case there was any suction there but...

I have tried turning, pulling everything but it just doesn't give. After talking to the dealer he said all I need is to just pull it out. The tube has one bolt holding it with two O rings but I don't know if it is above the oil level or not. I just purchased this tractor with 289 hours on it...

Anyone have trouble getting the transmission dip stick out to check the fluid? I have a B7510 and can't seem to be able to remove the stick. I have pulled and tugged then had others to do the same but it just doesn't seem to want to come out. Planning to change fluid and filters so if no other...