Search results

  1. Old Machinist

    LX3310 beep beep noise after shut down

    My LX3310 makes a beep beep, beep beep, sound in the speaker area right after shut down. Anybody know why?
  2. Old Machinist

    I despise buying home appliances such as refrigerators!

    My last refrigerator purchase was a Whirlpool purchased from Home Depot. It has a flaw in the door ice dispenser and the cubes hang up in it then fall out later as they thaw. I have to open the door each time I use it and push the dispenser door open to make sure it's cleared. My wife can't...
  3. Old Machinist

    Rear PTO seal blowing out

    The breather/vent theory is valid. That would be the first thing I would check for any seal leak. I have seen seals STOP leaking just by cleaning a stuck or clogged vent. My old JD855 was pushing oil out of the hydro side shaft. Dipstick remained in place. Found the breather tube clogged and...
  4. Old Machinist

    R14 vs Turfs on the same tractor

    Anybody have experience with the R14 vs turfs on the same tractor with just air in them? Did either ride smother than the other? My LX3310 has loaded R14s and I am wondering if getting the fluid out would improve the ride. It is very rough and ridged. I dropped the rears to 16 PSI and set the...
  5. Old Machinist

    New Member w/LX3310 Cab

    I have a 84" finish mower I was pulling with my JD with the Swisher connected to it.
  6. Old Machinist

    New Member w/LX3310 Cab

    This was my project today. Had to adapt the tongue on my Swisher to the Kubota for some wide path mowing.
  7. Old Machinist

    3 point vibration

    Not sure how common this is but my LX3310 had a horrible loud vibration in the 3 point lift eyes. I pulled them out and wrapped with duck tape. I also put a wrap on the pin and put it back in. Vibration noise is all gone.
  8. Old Machinist

    New Member w/LX3310 Cab

    Didn't see a new member intro section so I'll do it here and an admin can move if I missed it. I am an old retired machinist with a recent purchase of a 200 hour LX3310 Cab. Tractor came with the 535 Loader and a 72" MMM. I also have a New Holland 575E cab backhoe and a John Deere 4310 CUT so...