Search results

My seat suspension is gone/missing on my L295DT. I found a replacement off a L245 (part number 35110-1840). But it doesn’t come with, and I don’t think I have the front and back spacers in the parts diagram. Are these necessary, or can they be easily fabricated, or does anyone have a source for...

How simple/difficult would it be (any any recommendations/links) to replace the loader control valve while I’m changing all the hoses?

The manual says all the hoses are 3/8 but the hoses on the loader are 1/2 hose with 3/8 fittings (which are not readily available, so they have to be made). which do I trust? Assume this is an L1200 and the manual is correct and replace with 3/8 hose (assume someone Replaced with incorrect...

I would have to get more specific photos - the question is kind of general - will shortening hoses affect performance? Is there a reason hoses might be longer than from point A to point B (other than moving parts)?

I have a L295DT with a loader. Most of my hydraulic hoses need changed. A couple questions: 1) Does anyone know the loader model and where I can get a manual? 2) a lot of the hydraulic hoses have big droops or what seem to be unnecessary bends/radius. Can I or should I replace with shorter? Todd

Well - used tractor extensively over past week. When idling and sitting sideways on a grade (right side downhill) noticed some diesel slowly dripping near my boot on throttle pedal :(. I looked and it’s dripping off the area where mounting bolts are (which is the weld/seam. once level - the...

Just an update….I think it was really sludge and algae in the tank. Not really rust?? Took tank off, power-washed, cleaned valve. New line, fuel filter, reassembled, fresh fuel - got it running! I decided not to coat tank - hope it doesn’t bite me in the rear!

Lance, had a few different needs/inquiries for my L295DT 1) need the starter switch knob 2) my wiring is an absolute mess. Lots of wires terminated/going nowhere. It runs? Wondering if using a used wiring harness is possible/advisable? 3) hood/bonnet? Not sure how expensive shipping to NC...

I got the tank off! The valve did have a sludge "plug" in it, which was keeping the fuel from flowing. Quick look, I see just a little bit of rust in the bottom, but it does not look bad at all to me!? Not sure how to determine if I should just rinse out, dry, re-install....or if I should...

Thanks

I have the cowl and gas tank off for fuel issue, so I have a clear access to steering gearbox. The play seems before the Pittman arm - thus in the steering column/box. Does anyone know if there is any “adjustment” screw? I do see a square headed bolt!? previous posts seem to indicate there...

Can anyone give me help in how to get the cowl off? I Got the steering wheel off and instrument panel, but can’t get cowl off. Where are the acres holding it on?

Thanks. None of my gauges work (except glow plug lights)....lots of wires that seem to just "end". I'd really like to clean up all the wiring, but it very much overwhelms me! I really appreciate the advice on this forum. REALLY wish that I could link up with someone close by that we could...

Tractor sat quite a bit before I bought it. I changed fuel filter. When it stalled, I pulled off new filter and it had water and sediment in it. I took fuel line off at filter and fuel not flowing. So I disconnected at shut off and barely trickles out.

Just starting to use my L295DT after purchasing last year - new clutch, alternator/battery, hydraulic pump, fluids, etc Now it’s stalling out. Seems that tank/line clogged. Is it easier/better to drain/flush in place, or remove? Any directions on either? I tried to remove fuel tank today and...

Where do I find a steering column rebuild kit? I have an l295dt.

So I'm a First-Timer and bought an old L295DT. I am trying to do preventative maintenance (just assuming none has been done in a LONG time) and fix things as I discover them. I've changed the oil, greased, new battery, new alternator, new hydraulic pump and fluid, new fuel filter. So I want...

How do I know if it’s a “power steering” box?

The title says it all! With the tractor off you can turn the steering wheel a couple inches right or left. When you’re driving it’s very loose and constantly wanders. is this something that can be adjusted or tightened?