Search results

Here is wiring diagram. Post some photos of top of battery and where ground cable connects to chassis. A poor connection can produce a sound like you describe when it is asked to conduct high current like starting. Dave

Find and check for a slow blow fuse. It will be a 30 amp green one and located close to where the battery cable meets the starter motor. If it is blown there has to be a reason way and your story may have earlier chapters such as the connection of booster cables or a battery charger with cables...

You need to be prepared for a fight getting the tapered fit to release. The proper tool needs room above the stud to work which I dont think you have. A pickle fork bar is what you need because you do not care that it damages the rubber boot. pickle fork Dave

I do not think you have anything close to 15 gpm hydraulic flow. From the spec's it would be around 5 Dave

Check the envelope symbol at top right of forum page Dave

Take some photos of the top of your battery and also where the ground cable connects to the chassis. Post them here. A 13 year old machine will have some poor connections to the battery or frame. Unless you connected the booster cables reversed, the bigger battery will have done nothing. Dave

Check you still dont have the pto engaged Dave

From memory, i think your tractor's fuel shut off works the opposite to what you would normally expect. When the key is turned off power is sent to the fuel shut off solenoid for a few seconds by a timer relay to give the engine time to stop. Try unplugging the stop solenoid connector and...

Thanks for posting the solution. Doing so helps everyone learn! Dave

Which transmission does your tractor have. Manual gear or HST? Is it possible your high -low range selector is in neutral? What is happening with the pto shaft. Dave

The Kubota cables seems to be very high tech with the goal of keeping moisture out. However, should moisture get in you have an annoying problem. I have had moderate success buying a large horse size syringe and injecting gas line antifreeze through the rubber seals.My tractor has a cab and I...

What hydraulc fuilds and filters are you using. Others who have deviated from the /super UDT or I think it is called premium UDT in Canada, have reported erratic operation in temp extremes . Do you follow Kubota's extensive warm up regime. This is for the benefit of the transmission and...

There is a 426 page WSM that covers B2410, 2710 2910 and it has a supplement covering the B7800HSD. What transmission does yours have? Is there electrical work in your plans? Dave

Kubotabooks.com has the WSM including wiring diagram in the mower section. Kubotabooks My first guess is that a mistake was made installing the battery.. The Err 2 speaks to a power failure which is the blown fuses. You have a dynamo for battery charging which is almost bullet proof but the...

My post points out ONE consideration but not the only one I watched a John Deere engineering video on the subject of tractor hoping. They demonstrated that hopping starts to occur with a 6% wheel slip. It happens because of tire sidewall flexing Tire pressure, especially on the fronts, has a big...

I helped with the drive line repair of a TG1860. This flex coupling or the company Weasler that supplied it to Kubota may have what you need. These instructions came with the Kubota part. Dave

Look for the envelope symbol at top right of forum pages. If you see a red number 1 beside the envelope click on it. Dave

You are right........ any egg left over :) I will be more careful and perhaps get my eyes checked. Dave

The WSM had a section for upgrading the dynamo to a 40 amp alternator. I have attached it because it gives you ideas on how to install the alternator. Today's alternators with integral regulators makes things much easier. Dont get carried away with too big an alternator as drive pulley size will...

I have a much bigger blower on a M7040. My comments arise from a previous thread where someone bought a used blower and mounted it on a different end of the tractor than it was designed for. Dave