Search results

nope , it's all pretty simple , 3 different sets of shear bolts . I did check & the upper & lower augar are clocked 90 degrees out . Like mentioned I think the speed was teh main factor , & I'm guilty of it too . Ya start out nice & slow & as the ole back starts cramping up from lookin over your...

No lawn , just 27 acres of pine trees . She would never run my Case 580's , so she'd making up for time on the Kubota .

That is my blower . I'll check the clock on the 2 augars . That makes sense that they should be offset . The unit was barley used when we bought it . The guy boight a house that came with the tractor & blower . I think the tractor was in the neighborhood of 24-25 HP . The guy told me the loader...

Those broken exhaust studs will be real easy to fix once ya have the body off . With a couple of the right guys 3 days is very do-able . animals45

I checked the shear bolts when we shut it down last time , will check again tomorrow . We got a bunch of that special Sierra Cement most of the day . I'll wait till it crystalizes over night & then hit it . These blowers have a upper & lower horizontal impeller which pushes the snow into the...

Happy new years folks . I have a 3301HST with a Lorenz double augar blower on the back . A lot of times it seems that its pushing the snow instead of blowing . PTO speed is fine & driving speed is slow . I just was watching my wife using it & if she backs up theres a big pile on one sid with...

Well son of a gun , my bad animals45

You can probably get those spacers at Tractor Supply. Is teh top hole where the top link should be for a rear blower ? animals45

I had two different Case 580's before I got my Kubota 3301 . I really don't want to think bout pulling a ton of stumps with the Kubota after doing that with the 580's . 1 or 2 maybe . Like NCL suggested high side them when you cut the trees down , your going to want all the leverage you can get...

Some of them pine trees have a pretty bothersom tap root . good luck animal

I bought a pallet rack for my new shop along with a Harbor Freight mpotorcycle lift . I installed the lowest beams on the rack just above the collasped height of the motorcycle lift . I can store the lift under the rack when not in use. I still haven't put my motorcycle on it yet but it is so...

You put the bar in the link in the holes in teh end of your lift arms & bolt your attachment to the bar & then see what you need to do for teh top link. animals45

Get one of these & mount your smaller cat stuff to it https://www.tractorsupply.com/tsc/product/countyline-cross-drawbar-category-1-3-4-in-dia animal

Put a nut against the nut that is welded on if you can . animals45

NY-lock nuts like mentioned are a good way to go , You can also put a regular nut on , torque it down & then put a ny-lock against the regular nut & tighten it against the first nut while holding the first nut . Double nuts do a good job of holding things , if you want to go the extra mile a few...

Didn't see anything for a 3301 here . Anyone running a QH with a snowblower on a 3301 HST ? Good idea , bad idea ? thanks animals45

Check all the holes for alignment . The pin doesn't have to go in the center hole . animals45

If you have used the unit before you tried to tilt it there there could be some dirt/rocks in the holes . Try rocking the unit up & down on one side . I did find with mine that the blade hit the frame when trying to put it in max tilt . I marked the top of the blade where the interference was &...

Which pin are you pulling ? Sometime you have to jog the blade back & forth . You are removing the pin all the way ? animals45

Thank you very much for that info/link , I need to do some homework next . I'm sure there will be other questions thanks again animals45