Search results

Am I missing something? You said, "I have a feeling I would actually be better off buying one." One what? With 8" diameter being the largest your BH70 backhoe will take them out easily!

Johnxman good write up! I finally have the deck install mastered after 5 years! LOL!

What size deck do you have with 2" spacers? Im guessing the 60"? Also dragging the deck without turning the scalp wheels they will start to get chewed up from the concrete floor! Ive got too many multiple joint problems to not turn the scalp wheels so it will roll. Just yesterday I was outside...

I would agree with you if he said he was going to clear 4 acres of woods! Alas he never did. I guess as you were reading it wasnt long before you stopped paying attention to what the OP wrote and were just thinking this is an opportunity to post my usual " buy enough tractor" again. You said...

1 acre of stumps is a task for almost any tractor! Especially when they are large and close together with roots intertwined or you cant dig all the way around them because something is in the way. Small stumps no problem. Large stumps upwards of 24-30 inches dont think because you have a back...

Interesting! Traction and non marring. No crap from the township super about messing the new pav job! LOL!

Now thats the info im looking for. Chains on a BX with R4's without problems! THANKS!

I have considered studs but they are permanent.

Skeets I dont have spacers. They would help with clearance issues for chains but once the MMM goes on in summer the spacers would be a problem. No problem pushing snow here either! Its when going down my drive to the back of the property. Its steep and where I get 4 foot drifts if I try to push...

Hmmm I wonder is turfs are the same size as R4's?

Did you clean the suction screen? Could be part of the problem!

Maybe there is enough room for chains on a BX23S but I know its tight in there. If the chain comes loose its probably too late and the damage may be done but maybe not as the BX isnt going to spin a tire like a car. The loader valve is in the right fender well! I only need chains when going to...

The MMM is removed for winter or any FEL work. When the deck is on there is no room for spacers.

Does anyone use rear chains on a BX without spacers? I cant use spacers because of my 54" mid mount mower deck and im not going to install and remove spacers every winter. I know theres not much room for chains on the BX. Are there any other options im not aware of? I was thinking maybe some...

Its more the sturdy frame work he built rather than the top itself. Very nice job and I do like the fan!

Indestructible and made in the USA! Tractor Canopy - Rhinohide Canopies

Mlarv where did you get that seat cover?

Try cleaning all linkage with some solvent before greasing. Its an older unit maybe old tired grease caked up with dirt under there?

It should be a piece of cake! Got both hips done over 20 years ago thats when they went in through the butt cheek which is a longer recovery, now they go through the side. Youll be up and walking the same day! Best of luck to you!

Nor the equipment! Actually, my first few jobs were as a welder. There's days I wish I had a nice stick welder and mig but then I'd need torches and a plasma cutter a few good hand tools and so on. If your going to fabricate rather than just fix stuff it can be costly. It's something for me that...