Search results

Wildfire made a perfect one as to what it takes to repair and replace. https://youtu.be/jX5EncUkSQo if you have a google account subscribe to his channel as well

Working on putting in a drain in drive way and using little bx to move 4 bags if concrete at a time and dig out ground for drain boxed area. Sent from my iPhone using Tapatalk

My BX FEL does the same with the engine off. I can leave the FEL up and many hours later it is sitting on ground on its own. So with 6 inches it will drop slowly over hours on own. Sonwould i have a real problem and need fixed by dealer or just ignore issue as it is doing what i was told to do...

May not be the most up to date but this might help http://kubotabooks.com/AutoIndex/index.php?dir=Tractor%20Parts%20Manuals/&AutoIndex=a998af4841b12a21bcfcfa96e768c396 lists a bx1500D as a book Sent from my iPhone using Tapatalk

Check your DPF filter image is screen shot of error message from 2014. Sent from my iPhone using Tapatalk

Cannot hurt to just use pedal as the other is mostly a parking brake and emergency brake Sent from my iPhone using Tapatalk

Might have air leaking into the fluid. Check your FEL connections and reseat them after you relieve the pressure of FEL with controller. Sent from my iPhone using Tapatalk

Why not add algecide year around. Found my 5 gallon can had sludge in it and looked like green slime. Just need to filter out to smaller can and refill can again after adding both additives to can. I use the sta bil bottles for the anti gelling and the algecide. The alfecide is expensive @ $27 a...

I think and i am sure i am right and wrong.... If you think that running the fel at idle 1500 is better on the engine and pump. I think that it is doing more damage to the tractor in more ways than one. Rev it up to at least 2500 and use it like you stole it after of course you let the fluids...

I have never really checked mine but i know it appears to be loose when i check the engine oil about every other use. Sent from my iPhone using Tapatalk

I tried an email to my dealer from their web site with a picture and part number Sent from my iPhone using Tapatalk

As said in article for part it is # k1253-01660 for replacement part. Basic google search shows several known dealers for part. Mine looks to be dry rotting but says check dealer for replacement part under warranty Sent from my iPhone using Tapatalk

Tilled gardens again on BX. Moved grass clots to fill holes in old garage area. Planted tray of strawberries in new garden area. Seen fuel was getting close to being half empty and figured to fill up from fuel cans from winter with stabil mixed in. Used special screen funnel to filter out water...

About 3000 if using tiller or 2500 if i am mowing grass with MMM deck. But that's just me. Sent from my iPhone using Tapatalk

I would plan on a new oil pan and hope somewhere out there is a brand new clutch package. The rest does not look too bad. An aftermarket flapper is a given for muffler Sent from my iPhone using Tapatalk

I would guess check to see if the zerks are tight in place and tighten up if needed. Check the one that came out if they were just loose Sent from my iPhone using Tapatalk

After storm we had in our area little creek cleaned banks up and moved some rotten logs and a few tree stumps. Trie with little bx23 to pull out some of the light logs and one big log that must at least 500+ lbs just pulled it out and left on flat ground. Tractor was slow to run but got it done...

Check font axels to make sure that they are full. Usually as much as dealer sets up the axels might be full when you brought it but as used they need more udt added as gaps are filled. Sent from my iPhone using Tapatalk

Should be lower both and rear for controls at least on mine Sent from my iPhone using Tapatalk

Might just chain the bigger ones and rip out of ground in that case. Sent from my iPhone using Tapatalk