ruger1980's latest activity
-
Rruger1980 reacted to KubotaHawg's post in the thread Need ides for scarifying my rocky yard with
Like.
Welcome to Arkansas Ozarks—as a native of here, a few pieces of advice regarding your question: First, and not trying to discourage or... -
RProbably too small for a cylinder gland.
-
Rruger1980 reacted to TheOldHokie's post in the thread Repair case where tie rod (ball joint) connects? with Like.
The stud is a self locking taper. It spins because the matching female taper is damaged. The stud wont lock and loosens with use. Life...
-
RI’m a Canadian red seal jman welder. CWB certified structural welder. Stick and flux core All position. Post secondary welding...
-
Rruger1980 reacted to whitetiger's post in the thread Welding on newer machines with digital dashboards..... with Like.
I know several oil field welders who have a steel bed they welded together on the frame of a 1-ton truck. They spend hundreds of hours...
-
Rruger1980 reacted to North Idaho Wolfman's post in the thread Is anyone Monitoring Their Hydrostatic Oil Temps During the Past Few yrs of Elevated Summer Temps? with Like.
Another someone has been reading and relying on AI answers. :unsure:
-
RAll the above info is great... But it's more than likely not going to do much for you. You are more than likely going to need to do a...
-
RWhat I'm getting from it is that OP should send their FEL to the nearest shipyard and have it launched into the ocean, bad welds and all.
-
Rruger1980 replied to the thread Glow plugs not so glowing.OK don't listen
-
Rruger1980 replied to the thread Glow plugs not so glowing.Measure voltage drop using the method I describe not ohms with your multimeter. This is a much easier and accurate test.
-
Rruger1980 replied to the thread Glow plugs not so glowing.After rereading my post I wanted to make myself more clear. By testing I am saying testing of the ign. switch. So test from batt...
-
Rruger1980 replied to the thread Glow plugs not so glowing.As @NIW asked what is the voltage with the ign. sw. in the crank position? The glow plug circuit goes through the glow plug in the...
-
RDammit... I love discounts.
-
Rruger1980 reacted to Runs With Scissors's post in the thread Has anybody tried efficiamax? with Like.
Hahahah………I remember stocking the shelves with that stuff…..Along with “Motor Honey”…….Ahhhhh the “good ole days" My “snake oil alarm”...
-
Rruger1980 reacted to North Idaho Wolfman's post in the thread adapting older implements whose 3-p5 attachment points are too high? with Like.
Yea, you'll need to either put taller tires on your tractor, buy a bigger tractor, or rework the hitches if you want the attachment...