Recent content by NetMagi

lol, thx!

https://www.uline.com/Product/ProductDetailRootItem?modelnumber=H-6612 rated 600lbs each swivel on the bucket end, fixed on the tractor end

My version of a dolly for the BH-77 Backhoe for my L2501: Full build series (with testing) here: Part 1: Part 2: Part 3: Super happy with how this came out. I designed this quite a while ago and FINALLY got around to executing it. -Rich

thanks! I really geek out on the design stuff :)

oops, I forgot to post part 3 where I actually used it lol:

thx!

electric holding up very well for me so far ~3 seasons on it:

<deleted> (sorry, wrong thread)

dude. you do see the thread starts with a pic of it right? :p and then there's a link to like 5 more moarrrr pics a little further down in the same first post.

lol, thx

Couldn't stand the 'designed at 5pm on a Friday' parts-bin appearance of the Land Pride 3rd function kit on my L2501, or the wire dangling down just begging to be caught on a tree branch or something else. Really beefs up the feel of the stick, bringing it out to about 1" thick, and seals...

BH77 did a good job given how rocky it was

I found the highest temp when I was feathering the pedal on the HST (I know you have gear) to see only about 200rpm of bog. If I let is bog as far down as what you're seeing, my temps actually went down. Not sure how you could duplicate with a gear-drive using just elevation change. Ideally...

Just posted part 2, where I do all the wiring and controls:

It's very dependent on material choice and how tuned your print processes are. With good layer adhesion and the right materials., the parts are quite strong. I have some parts in rather high stress use cases for 5+ years that have far exceeded by expectations. I run a page and youtube channel...