nbryan's latest activity
-
Nnbryan replied to the thread Snowblower chain adjustment.Well I can say that once set as you describe with 1/16 play at tightest point of rotation the blower has performed just fine for me for...
-
Nnbryan replied to the thread Part number?.For a BX23D, anyway. No plain BX23 model listed on the parts finder here in Canada.
-
Nnbryan replied to the thread Part number?.
-
-
Nnbryan replied to the thread B3030 saftey switch fun. Won’t even crank.After analyzing whitetiger's first attachment, there's a seat tilt safety switch which is normally open, so I assume it would close when...
-
Nnbryan replied to the thread 9 Worst Things You Can Do to a Diesel Engine.With a PTO snow blower your LOT will probably run at the highest engine horsepower sustained output it will likely ever see. My 54"...
-
NNow my milkshake is contaminated with JD TransGard.
-
NPut your finger on one end of a straw. Put the open end of the straw in a glass of water. Note how far the water goes up into the straw...
-
NMy suggestion is to go through the installation and adjustments outlined in the manual. I bought my LX3310 with 200 hours on it and...
-
Nnbryan replied to the thread Hydraulic fluid dipstick question.The o-ring seals near the top of the dipstick prevent the transmission fluid from filling the dipstick tube from below. The o-rings...
-
Nnbryan replied to the thread BH77 Rotating Seat.200 isn't particularly heavy, IMO. I've been 180-190 through most of my tractor's 1300ish hours.
-
Nnbryan replied to the thread Top link spacing in quick hitch ?.Just more parts to get/make, fiddle with every install, then lose. For no tangible benefit.
-
Nnbryan replied to the thread BH77 Rotating Seat.This will have me looking at my own B2650/BH77 rotating seat mount now. "seat support on my BH77" meaning the tractor's rotating seat...
-
Nnbryan replied to the thread 3 point advise.Changing either changes the initial attack angle of the boxblade, which affects the adjustable top link position to level the box...
-
Nnbryan reacted to Lowlysubaruguy's post in the thread Working loader and three point to hard whats ok whats abuse with
Like.
Good advise I will attempt to not do that and its at very little angle cylinders are compressed most of the way. Crazy power and speed... -
Nnbryan replied to the thread Working loader and three point to hard whats ok whats abuse.Sounds like you've got the right tractor for your job!
