Recent content by Mowbizz

I discovered a “leaky hydraulic hose” that is U-shaped where the metal lines are stuffed between the loader frame. I’ll see if the hose fittings are loose and go from there.

Nah…😝

Oops! Didn’t know the breather plugs had to be removed! I hope that’s all it was!

I know my left front axle leaks so I put some 90weight in last week and all of a sudden a giant puddle formed beneath it…could I have overfilled and the oil expanded and blew out the “vent” wherever that is?

I don’t have the K connect system on mine it’s the quick hitch that hangs on the front of the tractor then that coupled with the blower. It’s an older Bx25D

I just use the factory skids on my BX5455HD blower…set them all the way down and blow my gravel driveway easily. I sometimes take mine off “float” for challenging areas and have had no trouble for 6 yrs. On a side note, my original skids wore down unevenly so I grabbed a new set for this coming...

No “rats” here! Only mice and chipmunks…dryer sheets have worked for years! Maybe your rats would use the dryer sheets to wipe their a$$es after eating your wires!

I use Fluid Film as well. I just reached for the 1st can I saw…

Started having same issue with my BX25D recently. A little WD40 in strategic places and it’s behaving better. I do hate the “turning the seat” system but it is what it is…

Try stuffing scented dryer sheets in every nook n cranny…

Takes me an extra 10 minutes to balance my 3 Kubota blades after sharpening on my All American sharpening system…not taking chances of ruining my non-greasable spindles…wtf was Kubota thinking??

That’s what my sharpening system does!

Yikes!

What happened to the original studs? I have a Z422 as well…🤔

Not judging “but” does anyone else clean their zero turns after each use? 🙄