Recent content by Kaiten

My is g2160 as well. Do you have the parts number from 123bearing? I want to order the kit before I get it removed from the tractor. Order number would be fine, as 123bearing lady said that she can pull it up that parts number. Thanks.

what information do you need to provide to the vendor to get the right seal kit?

The gauge should be relatively accurate. I was working on a D782 recently and I got 360psi for all 3 cylinders. I took the top bock off, and found that there is lot of soot/dirt buildup on the rings. Hope this is the reason that I have low compression. Now all the rings are cleaned. I'm...

Is there any obvious issue that you can pick up from the pictures? The cylinders seem to be firm, not much give. One of the cylinder tops has some scorching.

Ok. I took the top block off. There are a lot of black soot inside the chamber. Here are some pictures. Would you please help me to understand what the next steps are. Thanks.

Howdy, folks. I recently got a G1800 in pretty bad shape: dirty and not running. It was covered with dirty and dust, a thick layer and everywhere. Power washed and started working on it. Cleared the fuel line, replaced the battery and cables, couple spliced wires, and replaced the...

I assume the starter did not kick in then. Could it be low trigger voltage at the starter? My G2160 had issues on starting due to low voltage. I installed a relay and solved the issue.

fuel issue?

someone in my neighborhood is selling a freeze damaged Kubota ZD21 with 900 hrs. She claims that "it runs and the hydraulics are strong but during the freeze it froze and it now mixes water with oil". Price is at $3500. Would this be an easy fix, or something major? What to look for when...

So I got the new setup installed on my G2160 today. Works like a charm! No more issues of starting :cool: Thanks for all the advise!

Looks great on you setup, lmichael! I found an old relay, and rigged the same harness. Will put it on the tractor this weekend. The relay I found is: Panasonic ca1a-dc12v-n aca1213. I don't have a voltage generator, so I put a 9V battery on it, and it clicked. With 4 AA battery (6.45V)...

Thanks a lot. Will check out the helper relay solution. For the fuel pump rebuild, it was a long story. Poor maintenance from the previous owner, incorrectly installed fuel filter (backwards), and Sea Foam usage clogged the pump. It was not difficult to rebuild the fuel pump by myself. The...

Howdy! Recently I got a low 380h G2160 in relatively good shape. Went through a fuel pump rebuilt journey. Now the machine is running fine, except intermittent hot start issue, especially after running the machine for more than half an hour in Texas hot weather. The starter solenoid clicks...

Item 31 is the pin