Recent content by chapman

Wolfman, When I had the arms up by operating the position control lever and applied downward pressure, the arms dropped while the pressure was on and back up when the downward pressure was released. I was planning to get the WSM and now I cannot delay it any longer. Thank you for your thoughts.

Wolfman, The hydraulic change lever moves up and down freely and appears to be in the full 3 point position. If I place the change lever in the down/back hoe position the arms do not rise. The feedback rod connected to the right arm has an adjust that can be made by loosening two nuts. Is it...

Wolf man, The feed back rod is moving with the operation on the three point arm, but I do not have power to lift the arm with a load. Lifts fine without a load.

I will provide as much of information as possible to insure a prompt response. I have a 2006 B21 TLB with approximately 620 hours. The backhoe has been removed for the third winter to allow the use of my 42 inch snow blower. The hydraulic/transmission fluid and filters were changed within the...

I am considering using Shell Rotella T6 synthetic engine oil for my 2006 B21 TLB with approximately 500 hours of personal use on my small property for landscaping. Is there an opinion on the 0W40 and 5W40. The summer temperature here is a high of 90F or 32C and the winter temps get as low 0F or...