ZD 21 deck hydraulic cylinder

[RHR]

Can the cylinder be repaired? It is leaking around the rod.

 

[Workerbee]

Most likely its the seal. Your first step is to remove the cylinder, then take the end cap off and get the seal for it. Or take tge cylinder in to a hydraulic repair shop.

 

[PoTreeBoy]

Your cylinder is single-acting, similar to the one on a GR2100. You don't actually remove the gland. There's no separate piston; the rod acts as a plunger. There's a clip to remove through the hose port; then the rod can be pulled out to replace the seal and wioer.

Here's a link

Kubota GR2100 Lift Cylinder

I am hoping to rebuild the lift cylinder on my GR but am having difficulty finding dismantling instructions for the cylinder. The holding pin on the right side of the plunging piston does not have an access hole in the frame for removal so I am assuming Kubota want you to dismantle some...

www.orangetractortalks.com

 

[RHR]

Your cylinder is single-acting, similar to the one on a GR2100. You don't actually remove the gland. There's no separate piston; the rod acts as a plunger. There's a clip to remove through the hose port; then the rod can be pulled out to replace the seal and wioer.

Here's a link

Kubota GR2100 Lift Cylinder

I am hoping to rebuild the lift cylinder on my GR but am having difficulty finding dismantling instructions for the cylinder. The holding pin on the right side of the plunging piston does not have an access hole in the frame for removal so I am assuming Kubota want you to dismantle some...

www.orangetractortalks.com

Thanks