Tilt cylinder (of top and tilt) for L3560 HSTC LE
- Thread starter BigOgre
- Start date
Yes sir. I would love to order from you but the last I check you were backed up 22 weeks and I need (want) it now. Tired of climbing on and off to adjust it
Check with WR Long. They have started to sell T&T units to retail customers. Should be 4 weeks or less and about as close to what I provide as there is.
I don't think that anyone has the correct side link in stock yet.
And just for an FYI, I am now at 26 weeks minimum.
Check with WR Long. 252-823-4570
I don't think that anyone has the correct side link in stock yet.
And just for an FYI, I am now at 26 weeks minimum.
Check with WR Long. 252-823-4570
Summit hydraulics has tilt cylinders: https://summit-hydraulics.com/product-category/hydraulic-cylinders/?filters=cylinder-type[5087]
I don't think that they have any that are specifically built for his model of tractor.
The couple that I have seen are more of a generic type. Not saying they they don't have specific model units. It takes time to get all the ducks in a row so to speak.
They may not..I didn't look up the range for the sidelink on the 3560. You'd obviously know the details on that more than I!I don't think that they have any that are specifically built for his model of tractor.
The couple that I have seen are more of a generic type. Not saying they they don't have specific model units. It takes time to get all the ducks in a row so to speak.
One is close. Mine is 15 3/8" - 20". I don't know if 5/8" would make that much difference or not.I don't think that they have any that are specifically built for his model of tractor.
The couple that I have seen are more of a generic type. Not saying they they don't have specific model units. It takes time to get all the ducks in a row so to speak.
GreensvilleJay
Well-known member
Equipment
BX23-S,57 A-C D-14,58 A-C D-14, 57 A-C D-14,tiller,cults,Millcreek 25G spreader,
It looks like landpride has one for the L series. See the link below. The spec's list all of the top and tilt options for a bunch of different models.
www.landpride.com
I ordered a top link for my LX.
Land Pride
I ordered a top link for my LX.
I was looking for off the shelf options but I'm going to call around on Monday. Thanks
The best that you will get without a long wait is from WR Long. 5" stroke, top 3/4" ball clevis is 1 9/16" wide at a 6* angle. Lower clevis has three 5/8" pin locations with a 15/16" inside clevis width made with 3/8" material. Pretty well matches the factory link, actually better since Kubota uses the same adjustable link for all of the Grand Ls even though they should not be the same.
I will call my dealer on Monday too.It looks like landpride has one for the L series. See the link below. The spec's list all of the top and tilt options for a bunch of different models.
Land Pride
I ordered a top link for my LX.
