New BH70 backhoe with a BH1976 thumb will not use all 6 positions. When the thumb is raised completely it still partially blocks the last hole so the pin will not go in. With the thumb down one position, digging is reduced with the thumb resting on the soil. Apparently this thing is made wrong, any suggestions or comments? Here are some photos showing the last available hole and where it should be, also one photo showing a non-locking nut spinning completely free.
I'm finding too many issues such as the seat not rotating because the seat belts were installed wrong, that photo is also included.
I'm finding too many issues such as the seat not rotating because the seat belts were installed wrong, that photo is also included.