I have been trying to get my 3 point arms working again. Replaced all the hydraulic fluid and filter. Also, have replaced the hydraulic pump, and the arms still don't work. Any suggestions would be appreciated. Love my old girl and summer is just around the corner... Thanks
3 point repair L2250
- Thread starter PMore
- Start date
fried1765
Well-known member
Equipment
Kubota L48 TLB, Ford 1920 FEL, Ford 8N, SCAG Liberty Z, Gravely Pro.
North Idaho Wolfman
Moderator
Staff member
Lifetime Member
Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
Does it have a loader on it?
There is a selector valve (slotted head shaft) on the side of hydraulic block just under the fuel filter housing, any chance you could give us a picture of that?
Is the three point feed back linkage attached?
Has it been checked for adjustment?
Have you observed the shaft going into the case move with movement of the position control?
Do you have the WSM (aka service manual)?
If not just ask!
There is a selector valve (slotted head shaft) on the side of hydraulic block just under the fuel filter housing, any chance you could give us a picture of that?
Is the three point feed back linkage attached?
Has it been checked for adjustment?
Have you observed the shaft going into the case move with movement of the position control?
Do you have the WSM (aka service manual)?
If not just ask!
No I haven't our local dealer just talked about changing the oil, and the pump I replaced on my own.
It does have a loader but it currently off, and I will take a picture tomorrow.
North Idaho Wolfman
Moderator
Staff member
Lifetime Member
Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
BINGO, Yahtzee, Par... enough games to the rat mobile!
Almost guarantee you the selector valve is in the wrong position!
Russell King
Well-known member
Lifetime Member
Equipment
L185F, Modern Ag Competitor 4’ shredder, Rhino tiller, rear dirt scoop
North Idaho Wolfman
Moderator
Staff member
Lifetime Member
Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
The last picture you put up, in the center of that block is the valve.
turn the selector to match the red circle.
I will give that a try tonight it would have been nice if the dealer told me about this by pass. Luckly this has been a year I didn't need her to plow the snow. But this Will be tried before the rebuilt bucket is going back on. Thanks!!!
Thank you, Thank you, Thank you I own this machine for 10 years never had the bucket off. Bucket started leaking real bad last summer, so getting ready for winter dropped the mowing deck, dropped the bucket off to rebuild the cylinders seals. And have been pulling my hair out since last year.......
Thanks again
Thanks again