Little Help?

[Ripp]

Can someone help me out? Not sure my FEL control is hooked up right. Part # is 27fabs6m1ab and the “in” line is hooked opposite the PB port. Not in the IN port.
Backstory; my 3pth moves when operate the FEL. Can’t seem to figure out why.

 

[PoTreeBoy]

Can someone help me out? Not sure my FEL control is hooked up right. Part # is 27fabs6m1ab and the “in” line is hooked opposite the PB port. Not in the IN port.
Backstory; my 3pth moves when operate the FEL. Can’t seem to figure out why.

The in should come from the pump discharge.
The pb should go to the 3ph valve.
The out should return to the transmission case.
Sounds like you may have a couple swapped. Does the FEL work ok?

 

[kubotafreak]

Sounds like the 3 point is being fed by the return to tank not pb.

 

[Ripp]

The in should come from the pump discharge.
The pb should go to the 3ph valve.
The out should return to the transmission case.
Sounds like you may have a couple swapped. Does the FEL work ok?

The fel works fine. Both the in and PB go to a box, with a lever on it, attached to the side of the block. I turn that lever to the left and the fel doesn’t operate R side the in. L side is hooked to the PB. From there the pb line becomes metal and goes all the way back to the 3ph.

 

[Ripp]

Sounds like the 3 point is being fed by the return to tank not pb.

The return comes out the fel control and go’s to a fitting almost under the seat of the tractor.

 

[Ripp]

The return comes out the fel control and go’s to a fitting almost under the seat of the tractor.

What I don’t understand is why it’s hooked up this way (in on the side) when there’s clearly an in right next to where the out is.