I have an M110X with an LA1953 loader. It has the euro global quick connection bucket system with the single manual lever for the two lower pins. Has anyone seen a kit or fabricated a system to convert this to an auto pin system, something I can control from in the cab when switching buckets? I have seen the Komatsu system which has a hydraulic diverter on the 3rd function valve connected to a cylinder controlling the pins. The euro global is similar in design but I have not found a kit to make the conversion. It seems like this kit should exist as this is a common attachment system, either factory Kubota or aftermarket, hydraulic or possibly electric actuated. Anyone know where to look for this? If nobody has seen a kit for this, has anyone fabricated something they are happy with and willing to share your design? Thanks!
Auto Pins for Euro Global Quick Connect
- Thread starter CatPoor
- Start date
Russell King
Well-known member
Lifetime Member
Equipment
L185F, Modern Ag Competitor 4’ shredder, Rhino tiller, rear dirt scoop
See post #13 in this thread
is that something like you need?
www.orangetractortalks.com
if so there are a few threads that cover both the hydraulic and electric actuators that you can find using a search
is that something like you need?
MX Series hydraulic quick coupler
Anyone here fab up a hydraulic quick coupler for a MX series tractor? I'm thinking about taking on the task because I got spoiled using them on other equipment I operate. Looking at things it doesn't look like to bad of a project since I already have plumbing up front from the 3rd function...
www.orangetractortalks.com
if so there are a few threads that cover both the hydraulic and electric actuators that you can find using a search
North Idaho Wolfman
Moderator
Staff member
Lifetime Member
Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
I looked up all the options, I don't see a Factory option for hydraulic closer for that style loader attachment.
I don't see why you couldn't do it, it's just going to take a little design and fabrication.
I don't see why you couldn't do it, it's just going to take a little design and fabrication.
Do you already have front remotes? Add an electric solenoid valve to divert flow to operate your coupler.
Thank you! This looks like the skid steer style mounts, but if I am fabricating my own, it is mostly the same approach and same parts that I need. Very helpful, appreciate it.See post #13 in this thread
is that something like you need?
MX Series hydraulic quick coupler
Anyone here fab up a hydraulic quick coupler for a MX series tractor? I'm thinking about taking on the task because I got spoiled using them on other equipment I operate. Looking at things it doesn't look like to bad of a project since I already have plumbing up front from the 3rd function...
if so there are a few threads that cover both the hydraulic and electric actuators that you can find using a search
I don't have the third valve in front yet. I can get an aftermarket for $1100. Not sure that is the best approach or an actuator. It might get to cold here for an actuator, most actuators I have seen are only rated to about -5. Thanks.
Yes, that is the setup. I think I can remove the lever system and add a cylinder or actuator between the pins. Just need to figure out a stop so I don't pull the pins to far. If that looks like a hard issue to work around, I might leave the lever system on and connect the cylinder to that instead. That way I retain the stops for the pins. Still thinking that one through. Thanks.