Injection pump

brooster

Member

Equipment
B5200, BX2360, L3940, Z781i KW
May 15, 2021
68
8
8
Troy NC
Alright Wolfman, I have run the tractor for two hours and been moving and leveling dirt for a turnout. When I started hydraulic fluid was at the add mark and the oil was a 1/4”
below full mark, now after the two hours oil is at the full mark and I can’t really see any difference in the hydraulic oil.
 

North Idaho Wolfman

Moderator
Staff member
Lifetime Member

Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
Jun 9, 2013
30,185
6,355
113
Sandpoint, ID
It's still sounding like hydraulic to me, I know its frustrating not having an exact answer or conclusive results.
I would do 2 things:
First: Pull the hydraulic pump and replace the seal, if it looks bad there is your culprit.
If it doesn't still replace the seal, it's a cheap fix.
Then try it again, if you get the same result.
Second if it fails again: I would feed the injection pump from a container above the tractor bypassing all the other fuel systems.
 

brooster

Member

Equipment
B5200, BX2360, L3940, Z781i KW
May 15, 2021
68
8
8
Troy NC
It's still sounding like hydraulic to me, I know its frustrating not having an exact answer or conclusive results.
I would do 2 things:
First: Pull the hydraulic pump and replace the seal, if it looks bad there is your culprit.
If it doesn't still replace the seal, it's a cheap fix.
Then try it again, if you get the same result.
Second if it fails again: I would feed the injection pump from a container above the tractor bypassing all the other fuel systems.
How difficult a job is replacing the seal? Does Kubota sell a kit to rebuild it? Thx again
 

lugbolt

Well-known member

Equipment
ZG127S-54
Oct 15, 2015
5,205
1,889
113
Mid, South, USA
send an engine oil sample off for analysis. That'll tell you exactly what it is. Diesel or hydraulic juice.
 

North Idaho Wolfman

Moderator
Staff member
Lifetime Member

Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
Jun 9, 2013
30,185
6,355
113
Sandpoint, ID
How difficult a job is replacing the seal? Does Kubota sell a kit to rebuild it? Thx again
Super easy job to do.
Remove one nut, one bolt, and a couple lines.
Pop the pump out pull the E clip than the seal, replace the seal replace seal replace E clip reinstall done.
Seal P/N 31381-76390
 
  • Like
Reactions: 1 user

Pau7220

Well-known member

Equipment
L3650 GST, Landpride TL250 FEL w/ Piranha, 6' King Kutter, GM1084R Finish
Aug 1, 2017
785
278
63
Scranton, PA