L2501 3PH stabilizer problem

[Pawnee]

I turned the pins around on my rotary cutter but it was really narrow then so I ended up with one pin normal and the other turned around.
That was the best solution.
Other than spacers, which I think will put everything right.

 

[NvRudder]

Something doesn't make sense here...
My new L2501 w/R14's measures 30.5" between the tires...
Attaching QH with QH compatible Rear blade and attaching non-QH 60" Allied Snowblower also presents no issues with manual Stabilizer to Tire clearance...

 

[Chanceywd]

Something doesn't make sense here...
My new L2501 w/R14's measures 30.5" between the tires...
Attaching QH with QH compatible Rear blade and attaching non-QH 60" Allied Snowblower also presents no issues with manual Stabilizer to Tire clearance...

I have the same tractor and tires as yours NvRudder. I just measured a bit over 30" between. The wheels say titan EW and this #0319939 then 19.5x12.25. Are the OP's wheels the same? Maybe not the same wheels or dealer got them mixed between two tractors?

 

[NvRudder]

I have the same tractor and tires as yours NvRudder. I just measured a bit over 30" between. The wheels say titan EW and this #0319939 then 19.5x12.25. Are the OP's wheels the same? Maybe not the same wheels or dealer got them mixed between two tractors?

My wheels are exactly the same as yours...
Some kind of mismatch or wheel substitution seems like a potential part of Pawnee's spacing issues???

 

[Orange man]

I have the same wheels, But what part of the tire are you guys measuring?

 

[Chanceywd]

I have the same wheels, But what part of the tire are you guys measuring?

The distance between the tires at sidewall, at the back of the tractor is where it is easiest to do.

 

[Orange man]

My tractor measures 31.5 wheel to wheel, at the cheek of tire its 29.750, out closer to tread its 30.5. So that's why I asked what point on the sidewall you are measuring. Air pressure and load on tire is going to change also. So maybe measuring wheel to wheel would be a good place to start.

 

[Chanceywd]

My tractor measures 31.5 wheel to wheel, at the cheek of tire its 29.750, out closer to tread its 30.5. So that's why I asked what point on the sidewall you are measuring. Air pressure and load on tire is going to change also. So maybe measuring wheel to wheel would be a good place to start.

Ok I went to measure mine and got the same as you at the wheel rim edge, 31.5. My 30 measurement is at the fattest part if the tire between them.

 

[Pawnee]

I measured the inside wheel clearance at the wheels. It's 31-1/2". so the same as the others.
I guess the tires I got are a bit wider but they work great so I'm leaving them as-is.
I ordered wheel spacers so when I'm done I will have 35" wheel to wheel and about 32-1/2" between the tires.
That is enough to clear the lift pins on the rotary cutter with 1/2" extra so I will be one happy farmer(wannabee).

Thanks guys!