Search results

Based on your last post I wonder which end of the injector lines you tried to bleed? It needs to be done at the injector, not out of the pump. The object here is to allow the pump to fill the lines or the engine will never start. Once you see pulses of fuel at the injector, then tighten the...

Maybe here? http://www.ebay.com/bhp/kubota-steering-box

The term "no power steering" is key here. That can be/mean a number of different things. The steering wheel doesn't turn when usual effort is applied, as in low oil supply from steering pump. The wheel turns easily with no attempt at actually moving the tires, as with a steering cylinder...

I believe there are replaceable bushings in the mounting flanges, but they ride on solid parts, The front wear surface is a stub that's part of the center housing and the rear wear surface is part of the differential support housing. Doesn't take much movement in this are to cause the...

I'm referring to the entire front axle assembly where it pivots under the front casting. Jack the tractor front(not the axle, the tractor) up until the tires almost clear the ground but not quite. When you reach the right point, you can roll either front tire forward and backward and tell if...

Replacing the ring and pinion may not be necessary just yet. You should first concentrate on the cause of the spline damage/wear. The front axle pivots and bushings. Many Kubotas, particularly among the smaller ones, have no provision for greasing this area, thus they are often neglected. I've...

If I'm reading the parts book correctly(and it's always questionable) it looks like bucket cylinder for LB400 above ser number 16445 should take kit number 75545-64600.

No, that's not an issue. The oil is leaking out the axle seal, not at any housing joints.

That plug might be easy to access, but it's most likely a straight cut metric thread. You will need to remove it, identify the thread size/pitch, and then try to find matching adapter for your gauge to thread into. That may not be as easy as it sounds. I would look at the thermostat housing...

It may well be applicable. This is what I'm trying to figure out. Local dealer tech couldn't tell me that there are multiple compartments. ?? I realize this is a small town dealership, but they certainly should be up to speed on THAT! I stated that there's more to the story. After pulling it...

No takers yet. Certainly someone out there knows more about these tractors than I do.

I wouldn't know about power steering, that would make for a major project. On the other hand, for what it's worth, I had a similar problem with a Ford 1210 a few years back. Rebuilt the steering box, it broke. Had it "professionally" rebuilt, it broke. Again, OEM parts NLA. Some patience, a...

I won't swear to this, but what I see in the parts book shows an engine stop lever on the side of the block near the pump. I would remove that assembly, then looking through the exposed opening, try to move the rack by hand. If it's stuck, you should be able to tell at that point. If the pump...

Newbie to this site, so please bear with me. This involves some problems with an oil leak from a front axle seal. First question involves oil level(s). I see a fill port and (assuming) a level plug just below that on the center housing. Drain plugs on each bevel gear housing and (assuming) a...