Figured it out. Didn't even need to change the disc/clutch. The linkage was bent down, so when I pressed the pedal it wasn't engaging. Now, works great.
Hello, sir. I'm new to the site. I have a G1800 that I want to upgrade to an alternator based system and read on here on a post that you did this in 2017 and am asking for your help. I've heard of two "kits" but am not sure if either of them would work (even with a little modding) on my D662 engine. The two kits I've heard of are B7311 and B7324. Would either of these work, or is there another that could be recommended for this application. I've also started a new post asking this same question. Any help would be appreciated greatly!
Thanks for the reply to my post. I was wondering if you know which loaders will fit my L4400? I looked on TractorHouse but didn't find any LA 703 loaders and only one LA764 which might fit. Thank you again.
The program the email uses is a micro soft email program, I have gone to the micro soft help site and it was less than useless to me since I know noting about computers to start with,, However when the account was set up thats what the provider used.
Did you get it fixed? My crankcase broke after 325 hours! Almost $3K for a new engine!! I think I'm going to put a Honda IGX800 on it and screw the Kubota engine, if that's all the longer they last.
Hi Everyone
I have a 2017 L4060 with a LA805 FEL and my bucket is the round back L2296... What do you recoment for a Snow pusher --- I want to make sure my tractor/ loader could handle it.
Thanks you in advance
Hi! I saw in one of your posts from 2018 that you have a pattern for the B670 rear mounting bracket. Any chance I can get a copy? I recently picked up a B670 cheap.....because it doesnt have the rear mount.
Thanks!
Eric
newbie kubota bx owner. last tractor I had was an old JD 1A narrow front and a rickety loader attached. fun to look at, tall as a horse, and with two cylinders could burn gas, diesel, alcohol, who knows what else.
Really enjoying this machine as I get accustomed to the hydro and how it works. Still de-bugging her, but we're getting there slowly. I am thinking I'll keep the BH80 that came with it and just rebuild it with new pins. I have a lathe and milling machine so I should be able to custom machine new pins to fit the existing bushings and not have to replace them as well.
BX2200...Had 2 hydraulic leaks in loader section...fluid was light brown (with water)...replaced both lines and hydraulic/transmission oil. There's no place to bleed air on this machine. Now, the only way the loader moves or the brush hog lifts is with steering wheel moving. The brush hog mower only stays up for a while, then falls back down. Is this all just the process of getting air out of the system? If so, how long will this go on? If not...what else could be wrong?
not from around Gibsonia, but my uncle and cousins are, by chance I guess….