Would you happen to have a b7000 steering box laying around. Ordered a shaft from Greece. The distance between the top and lower race is a little longer than the old one. Plus the column and top of the box now will not contact the box by 3/16 of an inch. used fiber gaskets to get a small amount of resistance on the bearings. Thought that was ok till I found the bearing races no longer will need pressed into the top or bottom; they will fall out. Tried jb weld to stop them from turning lol everything felt good until I put it in the tractor and weight on the front axle. Will turn 1 1/4 turn of the wheel each direction but when turning full right and start back there is a loud crack and the steering wheel get 1/8 turn slop then will turn back. I thought I had the sector and ball nut centered in the vice felt smooth?