New profile posts

Thanks, not quite done yet but I'll continue to post pics. I'm actually creating a home for the tractor and a workshop for my wife. There's also a section for me. We used to have llamas and horses when the kids were little. But those days of cvaring for livestock are gone.

Your inbox is full; can I get your full name, address, phone number, and email?
Mark

hi I also have a m7950dt cab where is your block heater installed on your tractor. I want one but can't tell where it goes.
Thanks Todd

Nice barn restore. Thanks for the pics.

Thanks. Put the garage up 3 years ago the lift this year and had the car almost 8 years.

Wow nice garage. Sweet looking lift to, not to mention the gt500.

Hi Vic, I'm looking for a parts manual for a B7000 grey market tractor as I need parts for the front differential. Was told you might be able to help me. Thanks Scott

Hi Rick. Send me an email to my email address and I'll send you photos of the items I used for the reverse alarm.
Cheers.
Paul
specialty.repairs@nf.sympatico.ca

Happy birhday

Need advice. I have a L3800 with a loader. I purchased a set of 2 inch wheel extenders to allow me to use rear chains. I will be using a blade on the rear for snow in WI. What is the best chains to purchase? Any help or advice is appreciated. Thanks...

Need advise. Changing trans/hydraulic oil in my kubota l2500dt. What brand should i consider?

Greetings from Guthrie, Oklahoma

http://en.m.wikipedia.org/wiki/Guthrie,_Oklahoma

I have an L295DT tractor that I believe is a 1981...I recently found a loader for it, a Great Bend 260, with a little fabricating it mounted very nicely. I am told I can plumb it into the hydraulics on the tractor by removing the four bolt cap under the seat and installing a block assembly for the hoses. I saw two directional arrows under the four bolt cap, but my loader controls has three spots for hoses. Can anyone guide me in the process to plumb it up?

be who you seek to be: one moment, one breath, one step at a time

After replacing the clutch housing and clutch I got my clutch adjusted but it still won't disengage with the clutch pedal in. Any suggestions.

Good evening Vic, this is an awesome resource. I started a thread on this topic: "2001 L4610D HST oil leaking from propeller shaft" and it was recommended that I send you and IM to see if you might be familiar with this? I was told this was a problem and there might have even been a warranty recall from Kubota on this issue. Any help in determining the cause of the leak and the proper fix would be much appreciated.
Thanks
Robert

L345.. lifted 3 point up with mower on it , will not go down. left it like that all night normally will bleed down.the levers for the lift move all the way up and down.there is a linkage from the top arm under the seat that appears to be the feedback sensor that connects into the three point area . i dont see were it has moved.

Hi,
Does anyone on this forum know to adjust a clutch on a L245DT? I would sure like to know if I did it correctly or not.
Richard

I might not have the clutch adjusted correctly. Can anyone tell me in sequence how to setup clutch linkage and adjustment of a new clutch.

I replaced the clutch and throw-out bearing along with replacing cracked clutch case in my Kubota L245DT. I tried to start it and it sounded like the battery was dead so charged it. It was still hard to turn over and now it won't even do that it just clunks. Any ideas on what I did wrong. Would appreciate any help.
Thank you,
Richard