Hi all, getting the final touches done on the L2000DT. I bought some new amber fender light assemblies and am installing new wire from dash/console to fenders. I would like to know where to rout the wire, below the running board or along top by the shifter? because whoever did the wiring before, well, not cool! BTW, I found the 2 wires that were supposed to go to the safety switch. They were tied together because the switch was no good. I replaced the switch and rewired it, all good with that now. I will post all the things I have done to this machine since I bought it in the near future. It was ALOT!. Thanks for all the help.
wiring routing question
- Thread starter Jim67
- Start date
This is on a L1500DT, but should be similar.........
Let me know if you need any other pics.
Attachments
Exactly what I was looking for, thanks! A couple of those metal tabs have broken off. Any ideas on replacements? Make them?
You may find something similar at Napa or others,
also easy enough to make.
If you make them, you can dip the ends in "Plastic Dip"
for tool handles or use heat-shrink tubing, depends how
authentic you want to go.