Will a BX2410 Quick Attach Fit & Work on a LA211?

[george20]

Hi,

I have a Gen 1 BX2230 with LA211 loader arms. I recently picked up the Titan 133210 after reading that other BX owners seemed to have trouble using it. Unfortunately, I didn't know the newer generations come with a quick attach plate which I don't have and seems to be difficult to come by for the LA211, at least without spending a fortune.

I stopped by my local Kubota dealer and they mentioned that it might be possible for the BX2410 Quick Attach Plate that comes with the newer models (BX80's?) might work if the pin points and sizes match up. I measured my bucket against the measurements I took of the BX2410 and it seems like it might work.

Has anyone been successful with using the BX2410 Quick Attach with the LA211 arms? Or, is there a recommendation for another compatible quick attach plate that doesn't cost an arm & a leg?

If not, would anyone in the Denver/Fort Collins areas be interested in a discounted brand new set of quick attach Titan pallet forks?

Thanks!

 

[North Idaho Wolfman]

You would need to measure the width of your loader arm pin on points measure inside and outside points
and you need to measure the width of the bottom of the center cylinder.
And you need the pin diameter size of the 2 pins.
Then go to a dealership and measure a new loader, if they are the same you should be fine.

 

[Soopitup]

FYI That adapter uses pins that have an egg shaped flange on the end with a hole for a bolt to secure the pin, instead of a through pin with a circular clip. So you'll probably need those pins also.
This is for the 2 outer pins. The pin for the hydraulic piston in the center has a through hole.

If pin on attachments for the BX80 series fits your loader that adapter will.
It may be easier to cross reference that way.