Wanted to buy three point attachment for B7100 d-p

[kaze]

Trying to find the three parts for attaching the three point to the tractor.
Cross bar. Bracket for hooking the tension chains on. Draw bar..
I prob have not named them correctly but need some help on this one. Seems there are not too many junk B7100's in the area.

Tried the West Kentucky and other sites some will not even answer and email and the ones that do answer just quote a price with out a photo of what you will receive.

Joe

 

[Carl in France]

Looks li,e yu just need a Cat 1 three point lift kit. They are relatively inexpensive.
Search for just that on the internet and you will get enough pictures of what parts they come with to work out what you need if not all the bits.

 

[Lil Foot]

I think might have the cross bar, (called a lower link pin) but it's at my place in the mountains, and I have no idea when I can get up there to check. Might be a week, might be a month. Anyway, when I can check, I will post to see if you still need one.

 

[Lil Foot]

After further thought (it's hell getting old) I remembered that I might have the two brackets that the stabilizers attach to. The ones shown in the diagram below are 90 degree, and the two sets I have are 90 degree and straight- I just don't remember which set is on my tractor and which set is surplus. Again, I will check as soon as I can.
The parts I may have are #34 and (2) #25 (straight or 90)
They are stock Kubota parts.

 

[CCox]

Kaze, I saw you inquired on the one being parted out. I'm just down the road from you and I use a great guy for fabrication in McCandless. If you find your parts but have something missing, I can put you in touch with him and you can use mine as templates if they're the same. I have a B8200.

 

[Lil Foot]

kaze-
I went to my place in the high country and brought back the parts. Here are some photos The bar is 16" long, hard to see in the pic.

 

[kaze]

bill
Somehow I missed this post. and just saw the photo. Where did you get that orange implement draw bar??
Joe

 

[Lil Foot]

Joe- that is the original stock cross bar & brackets from my B7100 . Because of the combination of the mounting plates for the backhoe and my Hodge stabilizers, the stock one was too short. I took an old hydraulic ram and turned a longer one for my tractor.
(19.5" vs 16" if I remember right)

 

[Lil Foot]

Crossbar SOLD.
Brackets still available.

 

[Lil Foot]

Brackets SOLD.

 

[kaze]

All pieces for the three point Draw Bar Center chain hook up outside L shaped chain hook up and the center implement draw bar found Thank everyone for the help. If the weather allows will send a photo

Kaze