V1505 not getting fuel past the pump

[Cmcnair55]

Hello, I have a kubota v1505 on a wood mizer sawmill. I cannot get fuel past the injection pump, I have replaced the glow plug relay and the shut off solenoid and still have no luck. Any advice would be much appreciated, thanks!

 

[JerryMT]

Hello, I have a kubota v1505 on a wood mizer sawmill. I cannot get fuel past the injection pump, I have replaced the glow plug relay and the shut off solenoid and still have no luck. Any advice would be much appreciated, thanks!

Do you have a CONTINUOUS flow of fuel to the inlet of the Injection pump (IP)?

 

[North Idaho Wolfman]

Have you tested the inputs to the shut off solenoid?

 

[Cmcnair55]

Do you have a CONTINUOUS flow of fuel to the inlet of the Injection pump (IP)?

Yes, I have a steady steam up to the pump.

 

[whitetiger]

Hello, I have a kubota v1505 on a wood mizer sawmill. I cannot get fuel past the injection pump, I have replaced the glow plug relay and the shut off solenoid and still have no luck. Any advice would be much appreciated, thanks!

A very simple test, remove the fuel shutoff solenoid from the injection pump and see if it will run. That will tell you if you have a mechanical issue or an electrical issue.

 

[Cmcnair55]

A very simple test, remove the fuel shutoff solenoid from the injection pump and see if it will run. That will tell you if you have a mechanical issue or an electrical issue.

So I still get no fuel after I removed the shut off solenoid and still have the same problem, what do I do from here?