Hello! A careless mistake for sure, however, I inadvertently shuffled the order of the tappet rollers and shims during a rebuild. They each have a number on the bottom of the shim which I understand denotes their thickness (07, 07, 10, 12). In which order do they go?
shims and wonder if anyone can help me with their correct placement?
V1305 Injector Pump Rebuild Tappet Shim order?
- Thread starter hoosierwoodguy
- Start date
This is an adjustment that would need to be done on an injection pump test stand. They don't go in any particular order. The followers, shims and plunger barrel assemblies are matched to provide equally spaced injection events.
There may be a process to make these adjustments measuring the height of the plunger in comparison to the barrel or specifically the fill port in the barrel but I do not have that procedure.
There may be a process to make these adjustments measuring the height of the plunger in comparison to the barrel or specifically the fill port in the barrel but I do not have that procedure.
North Idaho Wolfman
Moderator
Staff member
Lifetime Member
Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more