Uneven cut mddle ridge

[Kestrel]

I have a Land Pride RCR1260 rotary cutter that I use behind my B3030. Last cut I did was uneven with a higher ridge down the middle. Most likely a bent blade(s)?

 

[D2Cat]

Or it could be a spindle bearing going out and wobbling.

 

[Kestrel]

Thanks. We have hit a few rocks but haven't broken a shearpin. Rotary Cutter has about 12 hours on it.

 

[Diydave]

If its a finish mower, someone could also have put a blade on upside-down. I've done it, but never actually mowed with one upside-down...

 

[Kestrel]

Thanks. Its a brush hog. Set up by dealer. My neighbor thinks I may have cut too fast and the cuttings weren't clearing out of the middle quick enough. I usually cut in low gear. I did cut in medium gear this time as rain was coming. Live and learn!

 

[Diydave]

Thanks. Its a brush hog. Set up by dealer. My neighbor thinks I may have cut too fast and the cuttings weren't clearing out of the middle quick enough. I usually cut in low gear. I did cut in medium gear this time as rain was coming. Live and learn!

Also, check the level of the blades. The front should be about an inch lower than the back