Top and Tilt Kit for Bx50 Series

[bcuster]

Thinking/Dreaming of having a top and tilt kit (hydraulic top and side link) for my B2650. I've ordered the rear remotes for my B2650, and would like make them useful. Was looking at the Fit Rite Hydraulics website, and see they don't have the Bx50 series listed.

Being new to Kubota, and remembering seeing a post somewhere that I cannot recall, what tractor model (if any) has the same rear 3PTH assembly as the B2650/3350? Following are the models that they have kits for:

B2620
B2920
B2630
B3030
B3200
B3300SU

 

[Kennyd4110]

Call and ask Brian, I'm sure he can help.

 

[chad450r]

I highly recommend Fit Rite, Brian is stellar to work with and stands behind his product. On my B2650 I opted for only the Hydro top link as I have the ratcheting angle adjustment. I ran hoses back to the toplink from the Kubota factory 3rd fuction, this way I can swap lines and still use a grapple ect.. on the front.

 

[MtnViewRanch]

Thinking/Dreaming of having a top and tilt kit (hydraulic top and side link) for my B2650. I've ordered the rear remotes for my B2650, and would like make them useful. Was looking at the Fit Rite Hydraulics website, and see they don't have the Bx50 series listed.

Being new to Kubota, and remembering seeing a post somewhere that I cannot recall, what tractor model (if any) has the same rear 3PTH assembly as the B2650/3350? Following are the models that they have kits for:

B2620
B2920
B2630
B3030
B3200
B3300SU

Yes the hitch parts are the same as the models listed. I do not list tractors that I personally have not had the chance to measure. Part numbers do cross over though, so we would be good to go.

Fill out the contact page and I can get you a total bottom line cost.

 

[bcuster]

Thanks for the replies. Out of curiosity, Brian, can the tilt cylinder in this kit be switched from one side to the other if needed? and if so, what's the benefit (if any) of doing so? I assume the float function would be most used on the top link, but are there any other uses for float on the 3 point arms? Just wondering what kind of attachments would take advantage of these situations.....