hello all
Hope everyone is doing better than the last couple of years.
I am doing away with my #2 oil fired furnace (it burned a hole through
the bottom of the heat exchanger and its $2500 to replace)
So I have two, 275 gal tanks installed inside my workshop. One is full of #2.
I have a Kubota 5040 (2008 new) and I want to use the left over fuel
to run my baby for the next year. I am also thinking about having a diesel load
delivered in the tanks and setting up an electric pump setup so I can fuel
up from the workshop tanks as needed.
My question is, will #2 be ok to burn in my 5040 and next fillup I would
fill with K1 (only one tanks worth) so it would be good for winters (in New
England).
Any thoughts on the subject? Hate to waste
Hope everyone is doing better than the last couple of years.
I am doing away with my #2 oil fired furnace (it burned a hole through
the bottom of the heat exchanger and its $2500 to replace)
So I have two, 275 gal tanks installed inside my workshop. One is full of #2.
I have a Kubota 5040 (2008 new) and I want to use the left over fuel
to run my baby for the next year. I am also thinking about having a diesel load
delivered in the tanks and setting up an electric pump setup so I can fuel
up from the workshop tanks as needed.
My question is, will #2 be ok to burn in my 5040 and next fillup I would
fill with K1 (only one tanks worth) so it would be good for winters (in New
England).
Any thoughts on the subject? Hate to waste