Stripped Thread on 3 point pin Cat 1

[Dchemphill1]

I have a TSC 6ft blade on my L3901. The nut must have worked loose over the years and has stripped the threads so it can't be tightened...it just vibrates and is causing the hole in it is mounted in to wear. Any ideas on how I can get this old pin out and replace it with a new so I can tighten it down really well? Can I use a saws all with metal cutting blade? hack saw?

Thanks for any assistance.

 

[russell.still.5]

As long as it isn’t hardened steel, a reciprocating saw will cut it. I doubt it’s hardened, but if it is you will need a torch or abrasive wheel


Sent from my iPhone using Tapatalk