Slv65 error code e026 wont start

[kaffinated]

Error code E026. Cranks but won't start. 32 hours on machine. -2 degrees was plugged in.

 

[200mph]

Do you have a specific question you'd like the forum members to comment on?

This was from a SVL95 manual, so act accordingly.

E: 026 CRS CAN communication - --- Immediately contact your local
dealer

 

[Asacooper89]

Error code E026. Cranks but won't start. 32 hours on machine. -2 degrees was plugged in.

You ever fix problem I have a ssv65 doing same thing

 

[Brick Axelrod]

It’s a CAN communication issue. It’s may be a bad module, or if you were banging around a plug may have come undone. Code says to contact dealer. Let us know what they find so others can benefit from it.

 

[Asacooper89]

It’s a CAN communication issue. It’s may be a bad module, or if you were banging around a plug may have come undone. Code says to contact dealer. Let us know what they find so others can benefit from it.

Ya it’s been at the dealer a week the can’t figure it out

 

[ehenry]

Are Kaffinated and Asacooper89 the same person?

 

[Asacooper89]

Are Kaffinated and Asacooper89 the same person?

No

 

[ehenry]

 

[Fasteddy1]

You ever fix problem I have a ssv65 doing same thing

AsA Ed from the dealership have checked all connections and ohm wires like instructed by Kubota tech. All appear good ! got back in touch with Kubota tech. waiting for a answer from them on what to do next. Bye the way the other SS75 did have a skip but all codes have gone away and I ran the machine with no problems unloading trucks? The skip is not apparent anymore.

 

[Fasteddy1]

When we find out I will let all Know

 

[Fasteddy1]

Asa, What Axelrod is saying is what I had told you on day one. Kubota tech feels there is a bad pin in the CAN connector or pinched wire somewhere on the machine I will check that out tomorrow. Electrical problems can be real easy to find or very very hard to pinpoint. But we will find it!

 

[Fasteddy1]

Buy the way there are only 81 pins in that connector times two to check!

 

[Asacooper89]

Buy the way there are only 81 pins in that connector times two to check!

Do whatever you can it’s costing me 1000$ a week to rent a bobcat right now

 

[JPNATIOALLIFT]

was this ever fixed looking for info on my ssv65

 

[rabtech]

Did anyone ever post the fix for their e026 code. I have an svl95 that just shut off and the code is e026. We have checked every pin and every fuse and every relay. When you turn the key it will wait about 5 seconds and then give that error.