Hi, guys! Just bought this tractor and for the life of me, I cant see how this new spring fits in the shuttle shaft lever to keep tension on the lever. I understand it's supposed to keep the lever in the detent notch to make the safety switch but I dont see what the two little 90 degree prongs bent into the spring are supposed to engage. I've flipped it every which way one can and am NOT seeing it. Any help would be appreciated. Thanks!
Shuttle shift lever spring L3600
- Thread starter mosseater
- Start date
North Idaho Wolfman
Moderator
Staff member
Lifetime Member
Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
Here is a picture of the orientation.
Closed loop side of spring hits handle bracket
Open loop side of spring goes on top of bracket on tube
Closed loop side of spring hits handle bracket
Open loop side of spring goes on top of bracket on tube
Attachments
Thanks for the drawing. I thought that was right but I was trying to put the bar under the lever, instead of against the shaft where it's supposed to be. Thanks much!