Ripper type tooth for my Backhoe scoop

[Paul Rae]

Does anyone know of a ripper type tooth I can connect to my BX25D backhoe scoop.
I would prefer that it clamps onto the scoop so It is quick to install and remove.
I have several stumps I need to remove.

 

[Shawn T. W]

I don't think a clamp on will stay put once you start putting the power to it ...

https://www.bxpanded.com/bx25d makes a "Quick-On" which it's a matter of seconds to swap out stuff on the end ... They make a ripper tooth too ...

 

[Runs With Scissors]

I don't think a clamp on will stay out once you start putting the power to it ...

https://www.bxpanded.com/bx25d makes a "Quick-On" which it's a matter of seconds to swap out stuff on the end ... They make a ripper tooth too ...

Thats the system I have for my 77, and it works great.

The only “thing” is the “quick discount pin” kept falling/getting bumped out, so I went with a bolt and Ny-lock style nut.

It is a little annoying to have to use a wrench, but it sure beats looking for that pin when it falls out.

Even with that “flaw”, I would still recommend it.

I have pulled many stumps with mine. Some of them were “pretty good size” too.

 

[Shawn T. W]

I've only "lost" my pin once, and that was using the 6" trenching bucket in rocky ground ...

For those that don't know ... How it works is you hang the red pin in the slot, and then pivot the purple hole up and put in the pin, and fasten with the clip, that I "lost" in the first picture ...

If you click on the link in post #2 and look at the pictures, there is a video in there that shows it being done ...

I am EXTREMELY Happy with this system, it truly turns my TLB SCUT into a Swiss Army Knife Tractor with all kinds of extra capabilities!